Injection Actuation Pressure Control Valve - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-0333     | Crowfoot Wrench     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect wiring harness plug (2) from injection actuation pressure control valve (1) .
Show/hide table
Illustration 1 | g00639954 |
- Remove nut (3), spacer (8), and solenoid valve (7) from injection actuation pressure control valve (1) .
- Use Tool (A) and an extension in order to remove the injection actuation pressure control valve from the unit injector hydraulic pump.
- Remove O-ring seals (4) and (6), and backup ring (5) from the injection actuation pressure control valve. Inspect the components of the injection actuation pressure control valve for wear or damage. If any part is worn or damaged, use a new part for replacement.
Show/hide table
Illustration 2 | g00615757 |
Caterpillar Information System:
3054 and 3056 Industrial and Generator Set Engines General Coolant Information
3126B Marine Engine Crankshaft - Install
3126B Marine Engine Unit Injector Sleeve - Remove
3126B Marine Engine Unit Injector - Install
3524B Engines for Off-Highway Trucks Can Not Reach Top Engine RPM
3126B Engines for Caterpillar Built Machines Unit Injector - Remove
3003, 3013, 3014 and 3024 Industrial Engines Coolant Recommendations
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel Conservation Practices
3618 Engine Crankshaft Main Bearings - Remove
3612 and 3616 Engines Cylinder Head - Remove
C-10 and C-12 Truck Engines Water Pump
3003, 3013, 3014 and 3024 Industrial Engines Engaging the Driven Equipment
3126B Marine Engine Injection Actuation Pressure Control Valve - Install
3126B Marine Engine Unit Injector Hydraulic Pump - Remove
3126B Marine Engine Crankshaft - Remove
3126B Marine Engine Unit Injector Hydraulic Pump - Install
3176C and 3196 Engines for Caterpillar Built Machines Piston Cooling Jet
3126B Marine Engine Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Camshaft - Install
3126B Marine Engine Front Cover - Remove
3126B Marine Engine Front Cover - Install
3126B Marine Engine Housing (Front) - Remove
3126B Engines for Caterpillar Built Machines Camshaft - Remove
3054 and 3056 Industrial and Generator Set Engines Crankshaft Vibration Damper - Inspect