Crankshaft - Remove
Removal Procedure
Start By:
- Remove the camshaft idler gear. Refer to Disassembly and Assembly, "Camshaft Idler Gear - Remove and Install".
- Remove the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Fasten lifting slings and a hoist to each end of the crankshaft. Refer to Illustration 1.
Show/hide table
Illustration 1 | g00639918 |
- Remove bolts (2), the washers, and main bearing caps (3). Carefully remove crankshaft (1) from the cylinder block. The weight of the crankshaft is approximately 62 kg (137 lb).
Show/hide table
Illustration 2 | g00609985 |
- Remove the main bearings from the cylinder block. Remove the main bearings from the main bearing caps.
Caterpillar Information System:
3126B Marine Engine Unit Injector Hydraulic Pump - Remove
3126B Marine Engine Injection Actuation Pressure Control Valve - Install
3126B Marine Engine Injection Actuation Pressure Control Valve - Remove
3054 and 3056 Industrial and Generator Set Engines General Coolant Information
3126B Marine Engine Crankshaft - Install
3126B Marine Engine Unit Injector Sleeve - Remove
3126B Marine Engine Unit Injector - Install
3524B Engines for Off-Highway Trucks Can Not Reach Top Engine RPM
3126B Engines for Caterpillar Built Machines Unit Injector - Remove
3003, 3013, 3014 and 3024 Industrial Engines Coolant Recommendations
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel Conservation Practices
3618 Engine Crankshaft Main Bearings - Remove
3126B Marine Engine Unit Injector Hydraulic Pump - Install
3176C and 3196 Engines for Caterpillar Built Machines Piston Cooling Jet
3126B Marine Engine Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Camshaft - Install
3126B Marine Engine Front Cover - Remove
3126B Marine Engine Front Cover - Install
3126B Marine Engine Housing (Front) - Remove
3126B Engines for Caterpillar Built Machines Camshaft - Remove
3054 and 3056 Industrial and Generator Set Engines Crankshaft Vibration Damper - Inspect
3114, 3116, and 3126 Engines for Caterpillar Built Machines Water Pump - Disassemble
3126B Marine Engine Housing (Front) - Install
3126B Marine Engine Lifter Group - Remove and Install