Housing (Front) - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the joint face on front housing (2) with 8T-9011 Component Cleaner .
Show/hide table
Illustration 1 | g00748748 |
- Apply 4C-9500 Quick Cure Primer to the joint face. Allow the primer to dry for at least three to five minutes.
- Apply 1U-8846 Sealant to the joint face. Spread the sealant uniformly. Front housing (2) must be installed within ten minutes of applying the sealant.
Note: Do not allow the 1U-8846 Sealant to seal the main oil passage on front housing (2) .
- Position front housing (2) on the cylinder block.
- Install bolts (1) that fasten front housing (2) to the cylinder block and the engine oil pan.
- Install any external components, if equipped.
End By:
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
Caterpillar Information System:
3114, 3116, and 3126 Engines for Caterpillar Built Machines Water Pump - Disassemble
3054 and 3056 Industrial and Generator Set Engines Crankshaft Vibration Damper - Inspect
3126B Engines for Caterpillar Built Machines Camshaft - Remove
3126B Marine Engine Housing (Front) - Remove
3126B Marine Engine Front Cover - Install
3126B Marine Engine Front Cover - Remove
3126B Engines for Caterpillar Built Machines Camshaft - Install
3126B Marine Engine Vibration Damper and Pulley - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Piston Cooling Jet
3126B Marine Engine Unit Injector Hydraulic Pump - Install
3126B Marine Engine Crankshaft - Remove
3126B Marine Engine Unit Injector Hydraulic Pump - Remove
3126B Marine Engine Lifter Group - Remove and Install
3126B Marine Engine Cylinder Head - Remove
3126B Marine Engine Cylinder Head - Install
C-10 and C-12 Industrial Engines Speed/Timing Sensor
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Retarder (Compression Brake) Solenoid Circuit - Test
3054B Industrial Engine Engine Design
3054B Industrial Engine Fuel Injection Pump
3406E Truck Engine Cylinder Head Valves
3054B Industrial Engine Fuel Injection Nozzles
3612 and 3616 Engines Cylinder Head - Install
C-10 and C-12 Truck Engines Fuel Priming Pump and Primary Fuel Filter
3054B Industrial Engine Cylinder Head Valves