Engine Oil Pan - Disassemble
开始:
- 拆下油底壳。
Show/hide table
| 注意 |
|---|
|
在检查、保养、测试、调整及维修产品时，请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前，请准备好盛接液体用的适当容器。 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 卸下固定盖 (4) 的八个螺栓。 吸油滤网安装在外部，位于管组件内侧盖的后方。
- 如有必要，卸下固定 T 形组件 (3) 的八个螺栓。
注: 发动机上的 T 形组件具有供油端口，可向远程安装的预润滑泵输送发动机机油。 切断阀 (1) 位于 T 形组件和远程安装的预润滑泵之间。
注: 图中编号 (2) 为油底壳排油阀。
Show/hide table
图 2 g00553760 - 卸下抽吸管 (5)。
Show/hide table
图 3 g00553761 - 卸下卡箍 (6)。
- 卸下管组件 (7)。
注: 检查O形密封圈是否磨损或损坏。 必要时，更换密封件。
Show/hide table
| |
| 图 1 | g00609533 |
Caterpillar Information System:
3126B and 3126E On-highway Engines Alternator - Remove and Install
G3612 and G3616 Engines Engine Oil Pan - Install
3406E and 3456 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
C-9 Engines for Caterpillar Built Machines Engine Design
G3612 and G3616 Engines Engine Oil Pan - Remove
3126B Truck Engine Electronic Control System Components
Installation of the 161-0797 Governor Control (Load Share Module) as Service Replacement for the 131-5459 Governor Control (Load Share Module) {4490} Installation of the 161-0797 Governor Control (Load Share Module) as Service Replacement for the 131-5459 Governor Control (Load Share Module) {4490}
3406E and 3456 Engines for Caterpillar Built Machines Solenoid Valve (Compression Brake) - Test
3406E and 3456 Engines for Caterpillar Built Machines Control Valve (Compression Brake) - Test
3406E Generator Set Engines Annunciator Panel - Inspect
G3612 and G3616 Engines Engine Oil Filter Housings - Assemble
C15 Petroleum Generator Set Engines Piston Ring Groove - Inspect
G3612 and G3616 Engines Engine Oil Pan - Assemble
3126B and 3126E On-highway Engines Engine Control Module - Remove and Install
G3612 and G3616 Engines Oil Temperature Regulators - Remove and Install
3612 and 3616 Engines Aftercooler - Remove - High Performance Aftercooler
3126B and 3126E On-highway Engines Fan Drive - Remove
G3612 and G3616 Engines Priority Valve - Remove
3126B and 3126E On-highway Engines Fan Drive - Install
3126B and 3126E On-highway Engines Air Compressor - Remove and Install
G3612 and G3616 Engines Priority Valve - Install
G3612 and G3616 Engines Priority Valve - Disassemble
G3612 and G3616 Engines Priority Valve - Assemble
G3612 and G3616 Engines Vibration Damper - Remove