Engine Oil Cooler - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Before assembly, check the condition of the gaskets and the O-ring seals. If the gaskets or the O-ring seals are worn or damaged, use new parts for replacement.
- Lubricate the bore of oil cooler (3) with glycerin.
Show/hide table
Illustration 1 | g00594036 |
- Install O-ring seals (5) on oil cooler bonnet (4) of the oil cooler. Put clean engine oil on the O-ring seals. Lubricate the bore of oil cooler (3) with glycerin. Install oil cooler bonnet (4) into the oil cooler.
- Put O-ring seal (2) in position on oil cooler bonnet (1). Align oil cooler bonnet (1) with oil cooler (3). Put clean engine oil on the O-ring seal.
Show/hide table
Illustration 2 | g00594166 |
End By: Install the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Install".
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Shutdown Mode
3500B Engines and 3500 Engines with EUI Option Engine Speed/Timing Sensor
797 Off-Highway Truck Steering System Bearing Cup Cooling and Installation Procedure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Crankshaft Seals
G3606 and G3608 Engines Accessory Module Frame (Front) - Install
3500B and 3500B High Displacement Generator Set Engines ECM/Personality Module
G3500 Engines Turbocharger - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Fuel Injection Pump Housing and Governor - Remove
3406E and 3456 Generator Set Engines Engine Oil Cooler - Disassemble
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Normal Mode
3034 Engine for Caterpillar Built Machines Engine Oil Pump - Install
G3606 and G3608 Engines Accessory Module Frame (Front) - Remove
3126B and 3126E Truck Engines Engine Oil Temperature Sensor
3500B Engines and 3500 Engines with EUI Option System Overview
G3606 and G3608 Engines Heat Exchanger - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Service Mode
G3606 and G3608 Engines Magneto Drive - Remove and Install
G3606 and G3608 Engines Stub Shaft - Remove
3126B and 3126E Truck Engines Connecting Rod
3612 and 3616 Engines Flexible Coupling
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Pump - Install - 3003 Engines
G3606 and G3608 Engines Vibration Damper Guard - Remove and Install
3406E and 3456 Generator Set Engines Engine Oil Filter Base - Remove
3176C and 3196 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect