Engine Oil Filter Base - Remove
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 185-3630 | Strap Wrench Assembly | 1 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove plug (2) and drain the oil from the engine oil filter base into a suitable container for storage or disposal.
Show/hide table
 | |
| Illustration 1 | g00594540 |
- Use Tooling (A) to remove oil filter (3) .
- Disconnect oil tube assembly for the turbocharger (1) .
- Remove nuts (4) and the bolts that hold the engine oil filter base to the engine oil cooler and bolts (5) that hold the engine oil filter base to the cylinder block.
Show/hide table
 | |
| Illustration 2 | g00594549 |
- Remove engine oil filter base (6) .
Caterpillar Information System:
G3606 and G3608 Engines Vibration Damper Guard - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Pump - Install - 3003 Engines
3612 and 3616 Engines Flexible Coupling
3126B and 3126E Truck Engines Connecting Rod
G3606 and G3608 Engines Stub Shaft - Remove
G3606 and G3608 Engines Magneto Drive - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Service Mode
G3606 and G3608 Engines Heat Exchanger - Remove and Install
3500B Engines and 3500 Engines with EUI Option System Overview
3126B and 3126E Truck Engines Engine Oil Temperature Sensor
3406E and 3456 Generator Set Engines Engine Oil Cooler - Assemble
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Shutdown Mode
3176C and 3196 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
3612 and 3616 Engines Accessory Drive
3500B Engines and 3500 Engines with EUI Option Digital Sensor Supply
3406E and 3456 Generator Set Engines Engine Oil Filter Base - Install
3612 and 3616 Engines Accessory Drive
3176C and 3196 Industrial Engines Engine Monitoring System (EMS)
3500B and 3500B High Displacement Generator Set Engines Engine Speed/Timing Sensor - Calibrate
G3606 and G3608 Engines Gas Pressure Regulator - Install
3612 and 3616 Engines Accessory Drive
561N, 572R Series II and 572R Pipelayers and D10R, D11R, D5M, D5N, D6M, D6N, D6R, D6R Series II, D7R, D7R Series II and D8R Series II Track-Type Tractors Power Train Electronic Control System Electronic Control Module (ECM) - Replace
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Hourmeter Programming OP7
3126B Marine Engine Engine Oil Pan