Engine Oil Pan
Show/hide table
 | |
| Illustration 1 | g00595139 |
(A) Front (B) Rear | |
Apply 1U-8846 Gasket Sealant to four areas on the sealing surface of the oil pan. The areas are marked location (Y). The areas are at the corners of the oil pan in the following locations:
- connecting joint of the front housing and the front of the cylinder block
- connecting joint of the flywheel housing and the rear of the cylinder block
Use the following procedure to tighten the bolts for the oil pan.
Tighten four bolts (X) .
Start with bolt (Z) and tighten all remaining bolts in a counterclockwise sequence.
Tighten the bolts to the following torque. ... 31 ± 3 N·m (23 ± 2 lb ft)
Start again with bolt (Z) and tighten all remaining bolts in a counterclockwise sequence.
Tighten the bolts to the following torque. ... 31 ± 3 N·m (23 ± 2 lb ft)
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Hourmeter Programming OP7
561N, 572R Series II and 572R Pipelayers and D10R, D11R, D5M, D5N, D6M, D6N, D6R, D6R Series II, D7R, D7R Series II and D8R Series II Track-Type Tractors Power Train Electronic Control System Electronic Control Module (ECM) - Replace
3612 and 3616 Engines Accessory Drive
G3606 and G3608 Engines Gas Pressure Regulator - Install
3500B and 3500B High Displacement Generator Set Engines Engine Speed/Timing Sensor - Calibrate
3176C and 3196 Industrial Engines Engine Monitoring System (EMS)
3612 and 3616 Engines Accessory Drive
3406E and 3456 Generator Set Engines Engine Oil Filter Base - Install
3500B Engines and 3500 Engines with EUI Option Digital Sensor Supply
3612 and 3616 Engines Accessory Drive
3176C and 3196 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
3406E and 3456 Generator Set Engines Engine Oil Filter Base - Remove
3126B and 3126E Truck Engines Crankcase Breather
3126B Marine Engine Water Temperature Regulator
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0273 - FMI 00 Turbo Outlet Pressure above normal
Electronic Modular Control Panel II (EMCP II) For PEEC Engines AL Fault Codes
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 03 Right Turbo Inlet Pressure open/short to +batt
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 04 Right Turbo Inlet Pressure short to ground
3612 and 3616 Engines Flywheel
Electronic Modular Control Panel II (EMCP II) For MUI Engines Diagnostic Codes
3612 and 3616 Engines Engine Support
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 13 Right Turbo Inlet Pressure calibration required
3612 and 3616 Engines Engine Support
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0276 - FMI 03 Left Turbo Inlet Pressure open/short to +batt