3612 and 3616 Engines Caterpillar


Flywheel

Usage:

3616 1PD



图 1g00595270

(1) 对正标记

注: 安装飞轮时,将飞轮上导向孔附近的对正标记与曲轴上的对正标记对准。

(2) 在垫圈表面和螺栓螺纹上涂抹 4C-5593 防粘结剂 。 将螺栓再次拧紧至以下扭矩。 ... 800 ± 80 N·m (590 ± 60 lb ft)

多转 90 ± 5 度拧紧螺栓。

(3) 在飞轮上安装齿圈,使齿圈中的倒角朝向发动机。

Caterpillar Information System:

3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 04 Right Turbo Inlet Pressure short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 03 Right Turbo Inlet Pressure open/short to +batt
Electronic Modular Control Panel II (EMCP II) For PEEC Engines AL Fault Codes
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0273 - FMI 00 Turbo Outlet Pressure above normal
3126B Marine Engine Water Temperature Regulator
3126B and 3126E Truck Engines Crankcase Breather
3126B Marine Engine Engine Oil Pan
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Hourmeter Programming OP7
561N, 572R Series II and 572R Pipelayers and D10R, D11R, D5M, D5N, D6M, D6N, D6R, D6R Series II, D7R, D7R Series II and D8R Series II Track-Type Tractors Power Train Electronic Control System Electronic Control Module (ECM) - Replace
3612 and 3616 Engines Accessory Drive
G3606 and G3608 Engines Gas Pressure Regulator - Install
3500B and 3500B High Displacement Generator Set Engines Engine Speed/Timing Sensor - Calibrate
Electronic Modular Control Panel II (EMCP II) For MUI Engines Diagnostic Codes
3612 and 3616 Engines Engine Support
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0275 - FMI 13 Right Turbo Inlet Pressure calibration required
3612 and 3616 Engines Engine Support
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0276 - FMI 03 Left Turbo Inlet Pressure open/short to +batt
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0276 - FMI 04 Left Turbo Inlet Pressure short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0289 - FMI 03 Unfiltered Fuel Pressure open/short to +batt
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0289 - FMI 13 Unfiltered Fuel Pressure calibration required
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
3500B Engines Engine Oil Pan
3406E and 3456 Generator Set Engines Turbocharger - Remove
3406E and 3456 Generator Set Engines Turbocharger - Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.