Flywheel - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | - | Guide Stud 1/2 inch - UNF by 4 inch |
2 |
Start By:
- Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install" for the correct procedure.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts from Position (X) from flywheel (1).
- Install Tooling (A) in Position (X) to flywheel (1).
- Install a suitable lifting device onto flywheel (1). Support the weight of the flywheel. The flywheel can weigh
75 kg (165 lb) . - If necessary, remove bolts (2) that secure the housing for pilot bearing (3) to flywheel (1). Remove the housing for pilot bearing (3).
- Remove remaining bolts (4).
- Use the lifting device to remove the flywheel from the engine.
Show/hide table
Illustration 2 g01336669 Typical example - Inspect flywheel (1) and ring gear (5) for wear and damage. Replace any worn components or damaged components.
- To remove flywheel ring gear (5), follow Step 8.a through Step 8.b.
- Place the flywheel assembly on a suitable support.
- Use a hammer and a punch in order to remove ring gear (5) from flywheel (1).
Note: Identify the orientation of the teeth on the flywheel ring gear.
Show/hide table
Illustration 1 | g01336668 |
Typical example |
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Exhaust Pipe
C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Pump - Remove
C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Engine Oil Pump - Remove
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
773G and 775G Off-Highway Truck Power Train Differential
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
773G and 775G Off-Highway Truck Power Train Axle Mounting (Rear)
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Level Is Low
D11T Track-Type Tractor MID 082 - CID 1326 - FMI 02
C27 and C32 Engines for Caterpillar Built Machines Fan Drive
Cat® Terrain for Drilling User Guide for Drill Operator Declaration of Conformity
C6.6 Industrial Engine Flywheel Housing - Remove and Install - Standard Housing
CAESultra Glossary
777G Off-Highway Truck VIMSTM 3G and Payload Payload System
773G and 775G Quarry Trucks Chassis Electronic Control System Starting System