C6.6 Industrial Engine Caterpillar

Engine Oil Pump - Remove

Usage:

C6.6 667

Start By:

Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove" for the correct procedure.

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates.

Show/hide table

If suction pipe (1) has a support bracket, remove bolt (4) from bracket (3). Loosen bolt (2) for the retaining clip.
Note: Note the position and orientation of the components for the support bracket.
Remove bolts (5). Remove suction pipe (1) from oil pump (8).
Remove gasket (6) (not shown).
Remove bolts (7) and remove the assembly of engine oil pump (8) from the cylinder block.
Show/hide table

Illustration 2 g02429917
If necessary, remove bolts (13) and oil pump front cover assembly (9). Remove outer rotor (10) from the housing of the engine oil pump.
Note: Do not remove dowel (11) or dowel (12) from the housing of the engine oil pump unless the dowels are damaged.