Water Pump - Remove
Start By:
- Remove the fan and the fan pulley. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
- Loosen the hose clamps and remove the hose from the water pump inlet.
Show/hide table
Illustration 1 g02164768 - Remove bolts (4).
- Remove water pump (3) from front cover (1).
Note: If necessary, tap the water pump with a soft faced hammer in order to loosen the water pump.
- Remove gasket (2).
Caterpillar Information System:
C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Engine Oil Pump - Remove
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
773G and 775G Off-Highway Truck Power Train Differential
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
AP1055E and BG1055E Asphalt Pavers Equipped with a Cat C7.1 Engine Engine Oil and Filter - Change
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Is Low
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Exhaust Pipe
C6.6 Industrial Engine Flywheel - Remove
773G and 775G Off-Highway Truck Power Train Axle Mounting (Rear)
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Level Is Low
D11T Track-Type Tractor MID 082 - CID 1326 - FMI 02
C27 and C32 Engines for Caterpillar Built Machines Fan Drive
Cat® Terrain for Drilling User Guide for Drill Operator Declaration of Conformity