- Motor Grader:
- 120M (S/N: B9C1-UP; D9W1-UP)
- 12M (S/N: B9F1-UP)
Description of Change: The new lines group has been created in order to resolve issues with the location and the support of the shutoff valve for the heater supply.
Adaptable To: The new 246-6120 Heater Lines Gp should be installed with the corresponding procedure that is located below.
This change is effective for the serial numbers that are listed in Table 1.
Effective Serial Numbers     |
S/N:B9C00252-UP     |
S/N:D9W00105-UP     |
S/N:B9F00275-UP     |
Installation Without an Air Compressor
- Remove the following parts and discard the following parts: 208-1629 Elbow As, 302-2623 Tube As, 148-8370 Elbow As and 169-4279 Connector As. Refer to Illustration 1 for the locations of the parts.
Illustration 1 | g01765333 |
(1) 302-2623 Tube As (2) 208-1629 Elbow As (3) 223-5916 Manual Valve As (4) 8L-6005 Pipe Tee that is used on machines with an air compressor (5) 3K-7928 Elbow (6) 148-8370 Elbow As and 148-8370 Elbow As (7) 5P-0767 Hose |
- Install the 223-5916 Manual Valve As and the 5P-0767 Hose onto the coolant manifold of the engine with the 2D-8910 Elbow and the 002-6454 Pipe Nipple. Refer to Illustration 2.
Note: Make sure that the handle of the valve points upward when the valve is in the open position.
Illustration 2 | g01765354 |
(8) Water manifold (9) 002-6454 Pipe Nipple (10) 2D-8910 Elbow |
Installation With an Air Compressor
- Remove the following parts and discard the following parts: 208-1629 Elbow As, 302-2623 Tube As, 148-8370 Elbow As and 169-4279 Connector As. Refer to Illustration 1 for the locations of the parts.
- Install the 002-6454 Pipe Nipple and the 2D-8910 Elbow to the coolant manifold.
Illustration 3 | g01765393 |
(11) Supply to the cab heater (12) Supply to the air compressor |