Turbocharger Water Wash Procedure {1052}
Usage:
3606 (8RB),
3608 (6MC),
3612 (9RC),
3616 (1PD) Engines
Reference: Special Instruction, SEHS9929-01, "Turbocharger Water Wash Procedure"
The Referencespecial instruction is available through normal literature ordering channels. This special instruction provides complete information about the tooling required and the procedure to wash the turbine side of the turbochargers on 3600 Diesel Engines.
Caterpillar Information System:
1996/09/23 Caterpillar Now Has Parts Support For Previously Non-Supported Custom Parts {7567}
1996/09/23 Introduction Of New Spark Ignited Single-Cylinder Gasket Kits {7555}
1996/09/23 New Circuit Board Assembly And Modules Improve Serviceability And Reliability {1418,1550}
1996/09/23 New Bracket Available To Support Gas Engine Ignition Group Wiring Harness Assembly {1408,1550}
1996/09/23 Addition Of Sleeve And Removal Of Setscrew Prevents Binding Of Control Shaft {1266,7558}
1996/09/23 New Valve Cover Seals Are Available For Mechanical Unit Injector (MUI) and Electronic Unit Injector (EUI) Engines {1107}
1996/09/23 A Chamfer Has Been Added To Some Engine Cylinder Head Bolt Holes To Help Reduce Stress Concentrations And Prevent Cracks {1101}
1996/09/23 Replacement Turbocharger Cartridge Part Numbers {1056}
1996/09/23 Error In The Testing And Adjusting Manuals For Fuel System Adjustment Timing Pin {1272}
1996/09/23 New Mixer Assembly Provides Better Startability And Idle Stability {1266}
1996/09/23 New Governor Weight And Race Increase Durability {1264}
1996/09/23 New Piston Rings Extend Valve Service Life {1215}
1996/09/23 Improved Air Cleaner Element Assembly Used {1054}
1996/09/23 New Soot-Filter Available For Use With Air Cleaner Group {1055,1050}
1996/09/23 New Wastegate Shaft And Bushing Provides Better Wear Resistance {1057}
1996/09/23 New Rotocoil Assembly Used In Valve Rocker Arm Groups {1109}
1996/09/23 Caterpillar High Efficiency Fuel Filters Help Provide Maximum Fuel Pump And Fuel Injector Life {1261}
1996/09/23 New Clamp Assembly Used In Engine Oil Lines Groups {1307}
1996/09/23 Procedure To Install A Protective Fuse For Slave Relay Number 1 In The Engine Supervisory System (ESS) Panel {1900}
1996/09/23 Recommended Customer Communications Module (CCM) Electrical Power Source {1926}
1996/09/23 Help Available For PC Based Service Tools Used For All Electronic Engines {1902}
1996/10/01 Improved Breather Vent Helps Prevent Water Entry Into Altronic III Magnetos{1552}
1996/10/01 Improved Marine Engine Inlet Valves{1105}
1996/10/01 Improvements To Prevent Water From Entering The Flywheel Housing{1157}