A New Service Replacement Hose Is Now Available for Certain Seat Suspensions {7324} Caterpillar


A New Service Replacement Hose Is Now Available for Certain Seat Suspensions {7324}

Usage:

MT700 018
Caterpillar Products
All Machines

Description Of Change: A new service replacement hose is available for certain compressor kits within the seat suspension group. The new hose allows the replacement of the hose only, and not the entire compressor kit.

------ WARNING! ------

Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.


565-1487 Hose is made from high-temperature material and is intended as a universal replacement for any seat suspension that uses 4 mm (0.16 inch) hose. The new hose is 2133.60 mm (7 ft) in length. The hose should be trimmed to length before installation.

Note: When trimming, ensure that the cut through the hose is straight to allow a good seal with the connectors in the compressor kit.

The hose can be used with the following seat suspension groups used on broad range of Caterpillar products.

Caterpillar Information System:

Updated Cylinder Block Front Housing Gaskets are Now Used on Certain C27 and C32 Engines {1151, 1162, 7555} Updated Cylinder Block Front Housing Gaskets are Now Used on Certain C27 and C32 Engines {1151, 1162, 7555}
Improved Oil Filter Base Assembly is Now Used on Certain C7 Machine Engines {1306, 1308} Improved Oil Filter Base Assembly is Now Used on Certain C7 Machine Engines {1306, 1308}
Improved Oil Filter Base Assembly is Now Used on Certain C7 Engines {1306} Improved Oil Filter Base Assembly is Now Used on Certain C7 Engines {1306}
C27 and C32 Generator Set Engines Flywheel Housing - Remove and Install
140 Motor Grader Machine Systems Blower Motor (Air Conditioner and Heater) - Remove and Install
140 Motor Grader Machine Systems Seat - Remove and Install
Procedure for Installing the Product LinkTM PL631/PLE631 Is Now Available for Certain 374 and 390 Excavators, Mobile Hydraulic Power Units, and OEM Excavator Based Speciality Solutions {7606} Procedure for Installing the Product LinkTM PL631/PLE631 Is Now Available for Certain 374 and 390 Excavators, Mobile Hydraulic Power Units, and OEM Excavator Based Speciality Solutions {7606}
120 and 120 AWD Motor Grader Fuel System - Fill
120 and 120 AWD Motor Grader Stopping the Engine
120 and 120 AWD Motor Grader Mirror - If Equipped
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Restricted Visibility
140 Motor Grader Electrical Troubleshooting Operator Control Switch (Switch to Ground) - Test
140 Motor Grader Electrical Troubleshooting Relay - Test
140 Motor Grader Electrical Troubleshooting Sensor (Data Link Type) - Test
Axial Clearances of Front Pins Are Now Improved on Certain 320, 320 GCand 323 Excavators {5057, 6501, 6502} Axial Clearances of Front Pins Are Now Improved on Certain 320, 320 GCand 323 Excavators {5057, 6501, 6502}
Improved Integrated Voltage Regulator (IVR) Configuration is Now Available for Certain Cat® Engines {1410} Improved Integrated Voltage Regulator (IVR) Configuration is Now Available for Certain Cat® Engines {1410}
140 Motor Grader Electrical Troubleshooting Sensor Signal (Analog, Passive) - Test
C175-16 Generator Set Aftertreatment System - Inspect
140 Motor Grader Electrical Troubleshooting Sensor Signal (PWM) - Test
C4.4 Engines for Caterpillar Built Machines Fuel Injection - Engines with a Primary and Secondary Fuel Filter Base
Three60 Precision Controller Gen II Engine Warm Up Using Direction Disable Mode
New Software Is Now Used on Certain G3600 Engines {1920} New Software Is Now Used on Certain G3600 Engines {1920}
New Valve Bridge Design is Now Available for Certain G3400 Series Engines {1100, 1121} New Valve Bridge Design is Now Available for Certain G3400 Series Engines {1100, 1121}
New Software is Now Used on Certain 3500E Marine Engines {1920} New Software is Now Used on Certain 3500E Marine Engines {1920}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.