Payload Control System (PCS) 2.X Caterpillar


Wiring Harness (Open Circuit) - Test

Usage:

972G 1EW
断路或短路导线经常导致电气故障。

开路 - 导致电流不流动的电路故障。 断路可由导线故障或连接不良引起。

注: 正常闭合的电路中的电阻将小于 5 Ω。

测试是否存在断路

  1. 识别可疑电路的接头和导线编号。

  1. 切断钥匙开关和断路开关。

  1. 从线束上断开部件和电子控制模块(ECM)。

  1. 在一个断开的线束连接上,将一根跨接导线连在可疑导线的触点与机架接地之间。

  1. 在另一个线束接头上,使用万用表表笔测量可疑导线的触点与机架接地之间的电阻。

    如果电阻小于 5 Ω,则电路正常。

    如果电阻大于等于 5.0 Ω,则电路断路。 修理或更换线束。

参考机器电气示意图

Caterpillar Information System:

Programmable Relay Control Module (PRCM) Glossary of Terms
3608 Engine Air Prelube Pump Lubricator Oil Level - Check
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>7W-1877</B> Generator through <B>7W-8825</B> Generator
Programmable Relay Control Module (PRCM) Connector Contact Identification
3500 Engines For Caterpillar Built Power Modules Engine Oil Pressure is Low
Programmable Relay Control Module (PRCM) Electrical Connector - Inspect
3406E, C-10 and C-12 Truck Engines Severe Service Application - Check
SPT342 Truck Mounted Pumper Gauges and Indicators
3508B Industrial Engine with an ADEM 2 Electronic Control Module Emergency Stop Switch (Remote)
3524B Engines for 797 and 797B Off-Highway Trucks Crankcase Pressure
2000/06/01 Special Instruction, REHS0589-01, "Emergency Stop Circuit Improvement for the Electronic Instrument Panel to Control Engine Restart" is Available {7451}
3500B and 3500B High Displacement Generator Set Engines Measuring Inlet Manifold Pressure
C9 On-highway Engines Fuel System Primary Filter - Replace
Medium Wheel Loaders (MWL) Payload Control System (PCS) 3.0 Wiring Harness (Short Circuit) - Test
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor
G3516B Engines Engine Speed/Timing Sensor
EMCPII+ for Gas Engines GSC CID 0475 - FMI 03
PM3516 Power Modules Engine Oil and Filter - Change
EMCPII+ for Gas Engines GSC CID 0475 - FMI 04
EMCPII+ for Gas Engines GSC CID 0500 - FMI 12
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for MUI Engines)
G3516B Engines Throttle Actuator
37-MT, 41-MT, and 42-MT Series Starting Motors General Information
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for EUI Engines)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.