Programmable Relay Control Module (PRCM) Caterpillar


Glossary of Terms

Usage:

3516B 1NW
PRCM - Programmable Relay Control Module

RDM - Relay Driver Module

ECM - Engine Control Module

NO - Normally Open

NC - Normally Closed

DIAG - Diagnostic

CID - Component Identifier

FMI - Failure Mode Identifier

LCD - Liquid Crystal Display

LED - Light Emitting Diode

EPG - Electrical Power Generation

GENSET - Generator Set

DCV - Direct Current Volts

PROG - Program

I/O - Input/Output

Caterpillar Information System:

3608 Engine Air Prelube Pump Lubricator Oil Level - Check
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>7W-1877</B> Generator through <B>7W-8825</B> Generator
Programmable Relay Control Module (PRCM) Connector Contact Identification
3500 Engines For Caterpillar Built Power Modules Engine Oil Pressure is Low
Programmable Relay Control Module (PRCM) Electrical Connector - Inspect
3406E, C-10 and C-12 Truck Engines Severe Service Application - Check
SPT342 Truck Mounted Pumper Gauges and Indicators
3508B Industrial Engine with an ADEM 2 Electronic Control Module Emergency Stop Switch (Remote)
3524B Engines for 797 and 797B Off-Highway Trucks Crankcase Pressure
2000/06/01 Special Instruction, REHS0589-01, "Emergency Stop Circuit Improvement for the Electronic Instrument Panel to Control Engine Restart" is Available {7451}
3500B and 3500B High Displacement Generator Set Engines Measuring Inlet Manifold Pressure
3608 Engine Air Prelube Pump Lubricator Bowl - Clean
Payload Control System (PCS) 2.X Wiring Harness (Open Circuit) - Test
C9 On-highway Engines Fuel System Primary Filter - Replace
Medium Wheel Loaders (MWL) Payload Control System (PCS) 3.0 Wiring Harness (Short Circuit) - Test
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor
G3516B Engines Engine Speed/Timing Sensor
EMCPII+ for Gas Engines GSC CID 0475 - FMI 03
PM3516 Power Modules Engine Oil and Filter - Change
EMCPII+ for Gas Engines GSC CID 0475 - FMI 04
EMCPII+ for Gas Engines GSC CID 0500 - FMI 12
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for MUI Engines)
G3516B Engines Throttle Actuator
37-MT, 41-MT, and 42-MT Series Starting Motors General Information
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.