Fuel System Primary Filter - Replace
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
注意 |
---|
不要让脏物进入燃油系统。 彻底清洁要拆开的燃油系统部件的周围区域。 在所有拆开的燃油系统部件上安放适当的盖。 |
更多有关燃油粗滤器保养的资料,请参阅车辆原设备制造厂(OEM)提供的资料,或参阅燃油粗滤器原设备制造厂提供的资料。
Caterpillar Information System:
Payload Control System (PCS) 2.X Wiring Harness (Open Circuit) - Test
Programmable Relay Control Module (PRCM) Glossary of Terms
3608 Engine Air Prelube Pump Lubricator Oil Level - Check
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>7W-1877</B> Generator through <B>7W-8825</B> Generator
Programmable Relay Control Module (PRCM) Connector Contact Identification
3500 Engines For Caterpillar Built Power Modules Engine Oil Pressure is Low
Programmable Relay Control Module (PRCM) Electrical Connector - Inspect
3406E, C-10 and C-12 Truck Engines Severe Service Application - Check
SPT342 Truck Mounted Pumper Gauges and Indicators
3508B Industrial Engine with an ADEM 2 Electronic Control Module Emergency Stop Switch (Remote)
3524B Engines for 797 and 797B Off-Highway Trucks Crankcase Pressure
2000/06/01 Special Instruction, REHS0589-01, "Emergency Stop Circuit Improvement for the Electronic Instrument Panel to Control Engine Restart" is Available {7451}
Medium Wheel Loaders (MWL) Payload Control System (PCS) 3.0 Wiring Harness (Short Circuit) - Test
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor
G3516B Engines Engine Speed/Timing Sensor
EMCPII+ for Gas Engines GSC CID 0475 - FMI 03
PM3516 Power Modules Engine Oil and Filter - Change
EMCPII+ for Gas Engines GSC CID 0475 - FMI 04
EMCPII+ for Gas Engines GSC CID 0500 - FMI 12
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for MUI Engines)
G3516B Engines Throttle Actuator
37-MT, 41-MT, and 42-MT Series Starting Motors General Information
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for EUI Engines)
3500B Marine Engines Diagnostic Codes