Axle Housing - Assemble
组装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 1P-2420     | 变速箱修复台     | 1     |
B     | 6V-2156     | 连杆支架     | 3     |
C     | 9S-9099     | 活动扳手     | 1     |
D     | 1H-3107     | 拉拔器总成     | 1     |
E     | 1U-8697     | 密封安装工具     | 1     |
F     | 1U-8846     | 密封垫密封胶     | 1     |
注: 清洁度是一项重要的因素。 组装之前,应使用清洗剂彻底清洁所有零件。 让零件风干。 不要使用抹布擦干零件。 棉绒可能会留在零件上,可能导致以后出现故障。 检查所有零件。 如果任何零件磨损或损坏,则应使用新零件进行更换。
- 利用工具 (E) 安装密封件 (19) 。 关于正确的程序,请参阅拆解和组装, "Duo-Cone 通用密封件 - 安装"。
Show/hide table
图 1 | g00671305 |
- 安装轴承内圈 (20) 。
注: 利用所用润滑剂润滑轴承。
- 安装轴承外圈 (18) 。 利用工具 (E) 安装密封件 (17) 。 关于正确的程序,请参阅拆解和组装, "Duo-Cone 通用密封件 - 安装"。
Show/hide table
图 2 | g00671344 |
- 安装轴承外圈 (15) 。
Show/hide table
图 3 | g00671354 |
- 安装齿圈 (16) 和三个定位销 (14) 。
- 利用适当的起吊设备和工具 (B) 安装车桥壳体 (13) 。 利用工具 (A) 支撑车桥壳体 (13) 。 车桥壳体 (13) 的重量约为 88 kg (195 lb)。
Show/hide table
图 4 | g00671536 |
- 安装轴承内圈 (12) 。
注: 利用所用润滑剂润滑轴承。
- 安装螺母 (11) 。 使用工具 (C) 拧紧螺母 (11) 。 保留少许的轴承端隙。
Show/hide table
图 5 | g00670405 |
Show/hide table
图 6 | g00670407 |
注: 利用所用润滑剂润滑螺母。
- 利用工具 (A) 支撑车桥法兰。
- 安装工具 (D) ,如图所示。 将螺栓装入工具 (D) 的中心孔中。 利用扭矩扳手检查滚动扭矩。 记录滚动扭矩。 这便是密封阻力大小。
Show/hide table
图 7 | g00671551 |
- 使用工具 (C) 拧紧螺母 (11) 。 将螺母 (11) 上紧至 3 N·m 到 8 N·m (2 lb ft 到 6 lb ft) 的滚动扭矩。 用过轴承的滚动扭矩应当为 1.5 N·m 到 2 N·m (1.1 lb ft 到 1.4 lb ft)。 从中减去步骤 10 中记录的密封阻力大小。
- 将轴承 (10) 装入齿轮 (8) 中。
Show/hide table
图 8 | g00670404 |
- 安装齿轮 (8) 和两个垫圈 (9) 。
Show/hide table
图 9 | g00671595 |
Show/hide table
图 10 | g00671603 |
注: 销孔间必须相隔 180 度。 销孔必须与行星齿轮架平台面平行。 请参看图 9。
- 安装轴 (7) 。
- 安装两个销 (6) 。
- 利用凿子将销孔略微敲打变形,如图所示。 尺寸 AA 为 1.5mm。
- 对其余两个齿轮组件重复步骤 12 到 16。
- 利用工具 (B) 和适当的起吊设备安装托架组件 (5) 。 托架组件 (5) 的重量约为 28 kg (62 lb)。
Show/hide table
图 11 | g00670400 |
- 安装环 (4) 。
Show/hide table
图 12 | g00670395 |
- 利用适当的起吊设备将车桥壳体从工具 (A) 上拆下。 车桥壳体的重量约为 136.0 kg (300 lb)。
- 清洁车桥壳体 (3) 的配合面,并涂抹一层连续的工具 (F) 。
Show/hide table
图 13 | g00671698 |
- 利用适当的起吊设备安装车桥壳体组件 (1) 。 安装 12 条螺栓 (2) 和垫圈。 将螺栓 (2) 上紧到 300 ± 40 N·m (222 ± 30 lb ft) 的扭矩。 车桥壳体组件 (1) 的重量约为 136.0 kg (300 lb)。
Show/hide table
图 14 | g00663942 |
End By:
- 安装摆动桥壳体。 请参阅 拆解和组装增补, "摆动桥和耳轴轴承 - 安装"。
- 安装固定桥壳体。 请参阅 拆解和组装, "固定桥 - 安装"。
Caterpillar Information System:
TH62, TH63, TH82, TH83 and TH103 Telehandlers Engine Supplement Electric Starting Motor - Remove and Install
TH62, TH63, TH82 and TH83 Telehandlers Hydraulic Tank Breather - Clean
3508B and 3512B Engine Supplement for 776D, 777D, and 777D HAA Tractor/Off-Highway Trucks Refrigerant Compressor - Remove and Install
2000/07/10 A New Receptacle Provides a Reliable Connection {1408, 1431, 5258, 7301}
TH62, TH63, TH82, TH83 and TH103 Telehandlers Engine Supplement Air Cleaner - Install
3508B and 3512B Engine Supplement for 776D, 777D, and 777D HAA Tractor/Off-Highway Trucks Oil Pan - Remove
3508B and 3512B Engine Supplement for 776D, 777D, and 777D HAA Tractor/Off-Highway Trucks Fan Drive - Install
TH62, TH63, TH82, TH83 and TH103 Telehandlers Engine Supplement Air Cleaner - Remove
TH62, TH63, TH82 and TH83 Telehandlers Hydraulic System Oil Filter - Replace
TH62, TH63, TH82, TH83 and TH103 Telehandlers Engine Supplement Battery - Remove and Install
TH62, TH63, TH82 and TH83 Telehandlers Hydraulic System Oil - Change
IT28G Integrated Toolcarrier and 928G Wheel Loader Steering System Steering Cylinder
TH62, TH63, TH82 and TH83 Telehandlers Pulley for Boom Extension Chain - Lubricate
3034 Engine for Caterpillar Built Machines Turbocharger - Inspect
D400E Series II Ejector Truck Ejector Blade Cutting Edge - Check/Adjust
TH62, TH63, TH82 and TH83 Telehandlers Quick Coupler - Lubricate
IT28G Integrated Toolcarrier and 928G Wheel Loader Brake and Fan Drive System Brake Accumulator
2000/06/19 New Brackets are Needed When a New EMS Panel is Installed {7490}
CS-531D, CP-533D and CS-533D Vibratory Compactors Vibratory System General Information
TH62, TH63, TH82 and TH83 Telehandlers Radiator Core - Clean
TH62, TH63, TH82 and TH83 Telehandlers Radiator Screen - Clean
2000/05/22 New Sender Assembly for the Fuel Level has Improved Service Life {1273}
3408E and 3412E Engines for Caterpillar Built Machines Engine Sensor Open/Short Circuit - Test
2000/06/12 New Parts for the Controls of the Individual Clutch Modulation (ICM) are Available {3083}