Illustration 1 | g00711944 |
125-0373 Hydraulic Cylinder (Steering) |
Install the 125-0373 Hydraulic Cylinder (Steering) on the right side of the machine.
(1) Torque for the bolt ... 530 ± 70 N·m (400.0 ± 50.0 lb ft)
(2) Bore of hydraulic cylinder ... 69.850 ± 0.038 mm (2.7500 ± 0.0015 inch)
(3) Diameter of the rod ... 38.050 ± 0.038 mm (1.4980 ± 0.0015 inch)
(4) Before installation, apply clean grease to the threads on the head.
- Torque for the head ... 600 ± 130 N·m (440.0 ± 95.0 lb ft)
- Diameter of the lands ... 38.430 ± 0.030 mm (1.5130 ± 0.0012 inch)
(5) Before installation, lubricate the sealing lips with a small amount of the fluid that is being sealed.
(6) Before installation, apply 4C-4032 Bearing Mount Compound to the wiper seal groove.
Steering Cylinder Mounting Group
Illustration 2 | g00870466 |
Steering cylinder mounting group for the steering cylinder on the right side of the machine |
(1) 4E-4524 Pin Assembly has two designs for pin length. Both pin lengths are listed.
- Diameter of the pin ... 44.425 ± 0.008 mm (1.7490 ± 0.0003 inch)
- Length of the pin ... 149.00 ± 3.00 mm (5.866 ± 0.118 inch)
- Length of the pin ... 152.00 ± 2.00 mm (5.984 ± 0.079 inch)
- Length of the pin ... 149.00 ± 3.00 mm (5.866 ± 0.118 inch)
(2) Prior to assembly, apply 4C-4032 Bearing Mount Compound to the bore of the cylinder cap.
- Internal diameter of the bearing ... 44.450 + 0.0 mm - 0.013 mm (1.750 ± 0.00 inch - 0.0005 inch)
- Depth for the bearing ... 5.5 ± 0.5 mm (0.22 ± 0.02 inch)
(3) 4E-4524 Pin Assembly has two designs for pin length. Both pin lengths are listed.
- Diameter of the pin ... 44.425 ± 0.008 mm (1.7490 ± 0.0003 inch)
- Length of the pin ... 149.00 ± 3.00 mm (5.866 ± 0.118 inch)
- Length of the pin ... 152.00 ± 2.00 mm (5.984 ± 0.079 inch)
- Length of the pin ... 149.00 ± 3.00 mm (5.866 ± 0.118 inch)
(4) Prior to assembly, apply 4C-4032 Bearing Mount Compound to the bore of the cylinder cap.
- Internal diameter of the bearing ... 44.450 + 0.0 mm - 0.013 mm (1.750 ± 0.00 inch - 0.0005 inch)
- Depth for the bearing ... 5.5 ± 0.5 mm (0.22 ± 0.02 inch)
(5) Use the 9D-1535 Thrust Washers on the top side of the steering cylinder and rod to obtain a gap of 1.50 mm (0.059 inch).