2000/06/19 Caterpillar

Motor Grader:

14G (PIN: 03L151-171; 96U4785-6338)

140G (PIN: 50H524-888; 72V4837-6652)

12G (PIN: 61M8401-10334)

120G (PIN: 61W291-461)

130G (PIN: 74V1771-2056)

120G (PIN: 87V5734-6978)

16G (PIN: 93U1869-2337)

Reference: Service Magazine, SEBD1338, 19 December 1983, "New Monitor Groups Will Keep Water Out of EMS Panel"

There are new operator monitor panels that are available for all machines that were equipped with electronic monitoring systems (EMS). When the new operator monitor panels were installed on certain motor graders, there was an interference with the mounting brackets.

The new 3T-9200 Operator Monitor is a direct replacement for the former 3T-3136 Operator Monitor.

When the 3T-9200 Operator Monitor is ordered, order the following brackets: 5T-8949 Bracket and 5T-8951 Bracket .

Use the following instructions to install the operator monitor panel.

Show/hide table



Illustration 1	g00712038

1. Remove existing mounting brackets (1) and (2) from the existing EMS panel (3) .

2. Remove the existing EMS panel and install the new 3T-9200 Operator Monitor .

3. Reinstall the existing mounting bracket (1) .

4. Install the new 5T-8949 Bracket in position (2) .

Show/hide table



Illustration 2	g00712048

5. Remove the indicator assembly for the articulation angle (4) from the operator console. Remove the existing bracket from the assembly.

   Note: The existing bracket is not shown.

6. Use a 5T-8951 Bracket to replace the existing bracket.

7. Reinstall the indicator assembly for the articulation angle gauge into the operator console.

8. Install the appropriate film for the EMS panel and the film for the blade float indicator on the EMS panel.

   Note: Refer to the following tables for the correct film for the EMS panel.