Make sure that all of the safety signs are legible. Clean the safety signs or replace the safety signs if you cannot read the words. Replace the illustrations if the illustrations are not visible. When you clean the safety signs, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety sign. Loose adhesive will allow the safety sign to fall.
Replace any safety sign that is damaged or missing. If a safety sign is attached to a part of the machine that is replaced, install a safety sign on the replacement part. Any Caterpillar dealer can provide new safety signs.
Read the Operation and Maintenance Manual
Illustration 1 | g00834797 |
The sign is located on the frame for the implement hitch.
Illustration 2 | g00809408 |
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the operation and maintenance manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your dealer for replacement manuals. Proper care is your responsibility. |
High Pressure
Illustration 3 | g00834828 |
The safety sign is located on the frame for the implement hitch and several other locations.
Illustration 4 | g00809414 |
Escaping fluid under pressure can penetrate the skin causing serious injury or death. Relieve pressure before disconnecting hydraulic lines, tighten all connections before applying pressure, and inspect all lines before each use. See "Safety" section in the operation manual for additional information. If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically removed within a few hours or gangrene may result. |
Folding Wings
Illustration 5 | g00834835 |
The safety sign is located on the frame at the front of the implement and several other locations.
Illustration 6 | g00809417 |
Failure of hydraulic components or accidental operation of hydraulic controls can allow implement or wings to fall and cause serious bodily injury or death!
|
Air in Cylinder
Illustration 7 | g00834896 |
The safety signs are located on each of the hydraulic cylinders.
Illustration 8 | g00809418 |
Air trapped inside hydraulic cylinders can allow implement or wings to fall and cause serious bodily injury or death. Purge air from hydraulic system by following detailed steps in the Operation Manual. |
Pinch Point
Illustration 9 | g00834903 |
The safety sign is located at the front of the implement on the linkages that are used for leveling and other locations.
Illustration 10 | g00809421 |
Pinch Point Stay clear of this area! Serious personal injury may occur. |
Height and Width
Illustration 11 | g00834910 |
The safety sign is located on the front of the frame for the implement hitch.
Illustration 12 | g00809423 |
Contact with a power line or other obstruction can cause damage, serious bodily injury or death. Be aware of implement transport width and height. Rear attachments will add to transport height and to transport width on some implements. See Operator Manual. |
Accidental Lowering
Illustration 13 | g00834921 |
The safety sign is located on the support bracket for the transport lock valves. The bracket is attached to the frame for the implement hitch.
Illustration 14 | g00809426 |
To avoid injury or death due to accidental lowering of implement, move lever to LOCKED position before transporting. |
Balance of the Implement
Illustration 15 | g00835077 |
The safety sign is located on the frame for the implement hitch.
Illustration 16 | g00835097 |
Unit May be Tail-Heavy The tongue may raise rapidly when unhitching from the tractor if the rear jack is not set in support position. A rear jack stand is required when heavy attachments are added to the back frame beam. Failure to heed this warning may result in serious bodily injury or death. |