Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
Disconnect batteries before performance of any service work. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Remove the left side front engine guard.
- Remove bolt (1) and remove bracket (2) .
Show/hide table
Illustration 1 | g00513626 |
- Disconnect wires (4) (not shown) from solenoid (3) .
Show/hide table
Illustration 2 | g00513687 |
- Remove nut (5) and the washer. Disconnect wires (7) from electric starting motor (6) .
- Use a suitable lifting device and a strap to remove the electric starting motor. Remove bolts (8) and remove electric starting motor (6). The weight of the motor is 26 kg (57 lb).
Show/hide table
Illustration 3 | g00513688 |
Installation Procedure
- Install electric starting motor (6) with a strap and a suitable lifting device. Install bolts (8). The weight of the motor is 26 kg (57 lb).
Show/hide table
Illustration 4 | g00513688 |
- Connect wires (4) to solenoid (3) .
Show/hide table
Illustration 5 | g00513687 |
- Connect wires (7) to electric starting motor (6). Install the washer and nut (5) .
- Install bracket (2) with bolt (1) .
Show/hide table
Illustration 6 | g00513626 |
- Install the left side front engine guard.
Caterpillar Information System:
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Control Valve (Pulled Unit)
784C and 785C Off-Highway Trucks Machine Systems Steering Tank and Filter - Assemble
550, 570 and 580 Wheel Harvesters Backup Alarm
24H Motor Grader Hydraulic and Steering System Position Sensor (Ripper)
583R Pipelayer Engine Supplement Alternator - Remove and Install
583R Pipelayer Power Train Duo-Cone Conventional Seals - Install
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Control Valve (Hoist)
24H Motor Grader Hydraulic and Steering System Position Sensor (Articulation)
793C Off-Highway Truck Machine Systems Gear Pump (Hoist) - Disassemble
966G Wheel Loader and 972G Wheel Loader Power Train Switches
3406E On-Highway Engine Electric Starting Motor - Remove and Install
24H Motor Grader Hydraulic and Steering System Temperature Switch (Hydraulic Oil)
583R Pipelayer Engine Supplement Hood and Dust Ejector - Remove and Install
769D Off-Highway Truck and 771D Quarry Truck Heating and Air Conditioning Control
784C and 785C Off-Highway Trucks Machine Systems Steering Tank and Filter - Install
Caterpillar Monitoring System General Information
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Bank Valve - Disassemble
3306B Industrial Engine Starting the Engine
784C, 785C and 785C HAA Off-Highway Truck Air System and Brakes Air Control Valve (Service Brake)
784C and 785C Off-Highway Trucks Machine Systems Check Valve (Primary Air Tank) - Remove and Install
C-10 and C-12 Industrial Engines Inlet Air Temperature Sensor
583R Pipelayer Power Train Duo-Cone Inverted Seals - Install
3406C Engines for Caterpillar Built Machines Fuel Injection Pump
583R Pipelayer Engine Supplement Muffler - Remove and Install