Fuel Injection Lines
Show/hide table
 | |
| 图 1 | g00493735 |
Show/hide table
 |
确保高压油管夹箍安装在正确位置。 未正确安装的夹箍可能使高压油管因振动而逐渐损坏。 损坏的油管可能渗漏燃油，引起火灾。 |
注: 所有尺寸参考垂直线 (1) 。 该线与 1 号喷油泵出口中心相对应。
(1) 通过 1 号喷油泵的垂直线
将所有喷油管卡箍拧紧至以下扭矩。 ... 2.25 N·m (20 lb in)
注: 为正确拧紧喷油管卡箍，可使用 6V-4980 扭矩改锥工具组件 。
Show/hide table
| 喷油管卡箍的位置 | |
| 尺寸 | 相对参考线的距离 |
| A | 281 ± 3 mm (11.03 ± .12 in) |
| B | 187 ± 1 mm (7.36 ± .04 in) |
| C | 35 ± 3 mm (1.38 ± .12 in) |
| D | 185 ± 3 mm (7.28 ± .12 in) |
| E | 282 ± 3 mm (11.10 ± .12 in) |
| F | 529 ± 3 mm (20.83 ± .12 in) |
Show/hide table
 | |
| 图 2 | g00510826 |
(2) 喷油管螺母
- 将喷油管螺母拧紧至以下扭矩。 ... 42.0 ± 7 N·m (31 ± 5 lb ft)
(3) 喷油器上的适配器挡圈
- 将适配器上的挡圈拧紧至以下扭矩。 ... 48 ± 7 N·m (35 ± 5 lb ft)
(4) 喷油管上的卡箍螺母
- 将喷油管卡箍上的螺母拧紧至以下扭矩。 ... 14 ± 3 N·m (10 ± 2 lb ft)
Caterpillar Information System:
24H Motor Grader Transmission Electronic Control System And Hydraulic Calibrations CID 0444 FMI 03 Magnetic Switch (Start Relay) Voltage Above Normal - Test
793C Off-Highway Truck Machine Systems Gear Pump (Hoist) - Install
24H Motor Grader Hydraulic and Steering System Pressure Switch (Steering)
793C Off-Highway Truck Machine Systems Gear Pump (Hoist) - Remove
784C and 785C Off-Highway Trucks Machine Systems Steering Tank and Filter - Remove
550, 570 and 580 Wheel Harvesters Swing Brake Manual Release
793C Off-Highway Truck Machine Systems Hydraulic Tank - Assemble
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Hydraulic Tank (Torque Converter, Pulled Unit, Brake, and Transmission)
550, 570 and 580 Wheel Harvesters Parking Brake Manual Release
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Hydraulic Tank (Torque Converter, Hoist, Brake and Transmission)
3408E and 3412E Engines for Caterpillar Built Machines Coolant Temperature Sensor
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Bank Valve - Install
24H Motor Grader Hydraulic and Steering System Temperature Switch (Hydraulic Oil)
3406E On-Highway Engine Electric Starting Motor - Remove and Install
966G Wheel Loader and 972G Wheel Loader Power Train Switches
793C Off-Highway Truck Machine Systems Gear Pump (Hoist) - Disassemble
24H Motor Grader Hydraulic and Steering System Position Sensor (Articulation)
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Control Valve (Hoist)
583R Pipelayer Power Train Duo-Cone Conventional Seals - Install
583R Pipelayer Engine Supplement Alternator - Remove and Install
24H Motor Grader Hydraulic and Steering System Position Sensor (Ripper)
550, 570 and 580 Wheel Harvesters Backup Alarm
784C and 785C Off-Highway Trucks Machine Systems Steering Tank and Filter - Assemble