Start By:
- Install the retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from the sudden release of high pressure oil. Be sure the engine has been shut off for a minimum of five minutes to ensure that the accumulator pressure is zero. The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or the cap from the top of the accumulator. |
Personal injury can result from hot oil or hot components. At operating temperature, oil is hot and under pressure. Hot oil can cause burns. Remove the fill cap only when the engine is stopped, and the fill cap is cool enough to touch with your bare hand. Do not allow hot oil or components to contact skin. |
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Drain the hydraulic oil from steering tank (1) into a suitable container. The capacity of steering tank (1) is
91 L (24 US gal) . Refer to Operation and Maintenance Manual, SEBU7173, "Steering System Oil - Change" for the correct procedure.Show/hide tableIllustration 2 g00493769 - Disconnect hose assembly (2) from steering tank (1).
Show/hide table
Illustration 3 g00493770 - Disconnect hose assembly (3) from steering tank (1).
Show/hide table
Illustration 4 g00493772 - Disconnect hose assembly (4) from steering tank (1).
Show/hide table
Illustration 5 g00493774 - Remove nine bolts (5) and the washers.
- Attach a suitable lifting device (not shown) to steering tank (1). Attach the lifting device to a hoist. Use the hoist in order to remove steering tank (1) from the platform. The weight of steering tank (1) is
113 kg (250 lb) .
Illustration 1 | g00493767 |