Drag Conveyors - Lubricate
Show/hide table
| NOTICE |
|---|
All daily grease lubricant should be applied at the end of each machine operation while the machine is still warm and the asphalt is still soft or not set up. Failure to do so may allow asphalt to harden around the seals and risk damaging a seal and lead to premature bearing failure. |
Show/hide table
 | |
| Illustration 1 | g00535735 |
Lubricate the two grease fittings on the right side of the machine. This will provide grease to the front bearings and the rear bearings. When you use a standard grease gun, pump between 30 and 40 pumps per fitting. The grease should purge the bearings.
Caterpillar Information System:
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Counterweight-Adjusting Machine Balance
D250E Series II and D300E Series II Articulated Trucks Steering Column Tilt and Telescope Control
D250E Series II and D300E Series II Articulated Trucks Steering Control
AP-1055B and BG-2455C Asphalt Pavers Cooling System Water Temperature Regulator - Replace
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-650B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-225C Asphalt Pavers Conveyor Planetary Drive (Auger) Oil Sample - Obtain
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-650B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-225C Asphalt Pavers Conveyor Planetary Drive (Auger) Oil - Change
D250E Series II and D300E Series II Articulated Trucks Differential Lock Control
D250E Series II and D300E Series II Articulated Trucks Transmission Control
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-650B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-225C Asphalt Pavers Conveyor Planetary Drive (Auger) Oil Level - Check
24H Motor Grader Transmission Electronic Control System And Hydraulic Calibrations Diagnostic Operation
3306C Engines for Caterpillar Built Machines Governor
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Starting Below 0°C (32°F)
D250E Series II and D300E Series II Articulated Trucks Hoist Control
3406C Engines for Caterpillar Built Machines Cylinder Head
D250E Series II and D300E Series II Articulated Trucks Hood Latch Control
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Mounted Chemical Tanks
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Cab - Install
D250E Series II and D300E Series II Articulated Trucks 3306B Engine Supplement Radiator - Assemble
D250E Series II and D300E Series II Articulated Trucks Machine Operation Information
Electronic Modular Control Panel II (EMCP II) For MUI Engines Block Diagram of Generator Set Control
D250E Series II and D300E Series II Articulated Trucks Secondary Steering
D250E Series II and D300E Series II Articulated Trucks Changing Speed and Direction
D250E Series II and D300E Series II Articulated Trucks Braking Operation
D250E Series II and D300E Series II Articulated Trucks Retarder