950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Caterpillar

Removal Procedure

Start By:

1. Remove the main control valve and the mounting plate. Refer to Disassembly and Assembly, "Main Control Valve and Mounting Plate (Lift and Auxiliary) - Remove".

Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.

Show/hide table



Illustration 1	g00339039
Typical Example

1. Place the plate assembly on wood blocks, as shown.

Show/hide table



Illustration 2	g00495632

2. Remove tube assemblies (1), (2), (3), and (5) .

3. Disconnect harness connector (6) .

4. Remove two bolts (4) and pilot diverter solenoid valve (7) .

Installation Procedure

Show/hide table



Illustration 3	g00495632

1. Install pilot diverter solenoid valve (7) and two bolts (4) .

2. Connect harness connector (6) .

3. Install tube assemblies (5), (3), (2), and (1) .

End By: Install the main control valve and the mounting plate. Refer to Disassembly and Assembly, "Main Control Valve and Mounting Plate (Lift and Auxiliary) - Install".