- Radiator
- Pressure cap for the radiator
- Fan for the radiator
- Drive pulley (if equipped) for the fan
- Hydraulic drive (if equipped) for the fan
- Water pump
- Drive pulley for the water pump
- Water temperature regulator
- Housing for the water temperature regulator
- Coolant temperature switch
The coolant flows from the bottom of the radiator to the centrifugal water pump. The water pump is installed on the cylinder block above the timing case. The water pump is driven by a pulley. The crankshaft pulley turns a belt which drives the pulley of the water pump.
The water pump forces the coolant to flow to the water temperature regulator. When the engine is cold, the water temperature regulator is closed. Then, the coolant flows directly into the cylinder head. When the engine warms, the water temperature regulator begins to open. Then, the regulator allows some of the coolant to flow to the top of the radiator.
The regulator opens fully when the engine reaches the normal operating temperature. When the regulator is fully open, the flow to the radiator is the maximum. However, the regulator does not close the flow of coolant into the cylinder head.
Coolant flows continuously through the cylinder head and the top of the cylinder block. This coolant flows into the back of the water pump from the cylinder block. This coolant then mixes with the coolant that is pumped from the radiator by the water pump.
The water temperature regulator maintains the correct engine temperature by adjusting the direct flow of coolant to the top of the radiator. The coolant is cooled by the radiator. Heat is removed from the coolant by cooler air which passes over the radiator fins. The fan causes a high volume of air to flow between the radiator fins in order to provide sufficient cooling. The coolant flows from the radiator through the bottom hose to the coolant pump.
The water temperature regulator is contained within the housing of the water pump on 3003 engines.
The 3013, 3014 and 3024 engines have a housing for the water temperature regulator. The housing is installed on the left side of the cylinder head.
Different machine models have different locations for the radiator, the fan, and the fan drive. These three components may be remotely mounted from the engine if the machine has a hydraulic drive for the fan.