Certain AP-650B And BG-225C Asphalt Pavers May Have Difficulty In Steering Under A Heavily Loaded Condition Caterpillar


Certain AP-650B And BG-225C Asphalt Pavers May Have Difficulty In Steering Under A Heavily Loaded Condition

Usage:

PAVING PRODUCTSAP-650B (9DN1-336),
BG-225C (5GN1-467) ASPHALT PAVERS

Problem:

The machine propel system high pressure relief valves may be set improperly.

Solution:

Use the KENR3554 System Operation Testing and Adjusting Manual and adjust the main relief valves to a new setting of 47800 ± 1000 kPa (6935 ± 150 psi).

COPYRIGHT 1998 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Pivot On Three-Point Hitch May Fail Pivot On Three-Point Hitch May Fail
The Suction Pipe Fitted Into The Fuel Tank Needs To Be Checked The Suction Pipe Fitted Into The Fuel Tank Needs To Be Checked
Drum Mount Fasteners Need To Be Checked Drum Mount Fasteners Need To Be Checked
Transmission Neutralization Transmission Neutralization
Adjustment Of The Brake Packs Adjustment Of The Brake Packs
Pavers May Have Incorrect Grade Timer Delay Relay Installed Pavers May Have Incorrect Grade Timer Delay Relay Installed
Certain Asphalt Pavers May Have The Wrong Orifice Fitting Installed On The Balance Lines Of The Propel Pumps Certain Asphalt Pavers May Have The Wrong Orifice Fitting Installed On The Balance Lines Of The Propel Pumps
Certain Pavers Have Had A Problem With The Balance Lines On The Propel Pumps Certain Pavers Have Had A Problem With The Balance Lines On The Propel Pumps
Failtures Of Chain Anchors And Pins Failtures Of Chain Anchors And Pins
Fan Drive Group Uses A Single Belt Fan Drive Group Uses A Single Belt
The Speedometer May be Incorrectly Set The Speedometer May be Incorrectly Set
Hard Engine Starting Hard Engine Starting
Checklist To Troubleshoot Low Power Complaints Checklist To Troubleshoot Low Power Complaints
Truck Payload Measurement System Downloading Truck Payload Measurement System Downloading
137-9822 Sonic Sensor For Feeder System May Not Perform Adequately 137-9822 Sonic Sensor For Feeder System May Not Perform Adequately
Brake Oil Cooler Guide Brake Oil Cooler Guide
Excess Material Causing Interference Between Hoist Cylinder Rod Eyes And Body Hoist Bracket Excess Material Causing Interference Between Hoist Cylinder Rod Eyes And Body Hoist Bracket
Structural Paint On Lift Arms Structural Paint On Lift Arms
Cab Air Filter Cab Air Filter
Transmission May Not Downshift Correctly Transmission May Not Downshift Correctly
Intermittent Loss Of Steering On Two Wheel Drive Two Wheel Steer C-Series Backhoe Loaders Intermittent Loss Of Steering On Two Wheel Drive Two Wheel Steer C-Series Backhoe Loaders
1R-1124 Driver Wheel May Have Lug Nuts Come Loose 1R-1124 Driver Wheel May Have Lug Nuts Come Loose
New Muffler, Stack, And Clamp Installed On Some Backhoe Loaders New Muffler, Stack, And Clamp Installed On Some Backhoe Loaders
Aftercooler Coolant Hose Clamps May Be Incorrectly Tightened Aftercooler Coolant Hose Clamps May Be Incorrectly Tightened
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.