Three60 Precision Controller Gen II Caterpillar

Show/hide table

Illustration 1	g03247017
Control head removal (1) Groove (2) Base plate (3) Set screw

1. Remove the control head from the cutout by loosening the set screw (3) in the rear. Loosen the screw until the control head cab be rotated to release the control head from the base plate front edge (2).
   Show/hide table

   Illustration 2	g03247020
   Drag adjustment screws (4) Drag adjustment

2. Inset an 1/8 inch hex key into the opening for each lever and set the drag by accessing the drag adjustment screw (4).

3. Tighten the drag adjustment screws until the desired drag is obtained over the full lever travel.

   Note: 0.45 kg to 0.91 kg (1 to 2 lbs) average drag is normally desirable.

   Show/hide table

   Illustration 3	g03264476
   Control head installation (1) Groove (2) Base plate (3) Set screw (5) Mounting surface

4. Tilt the control head and engage the groove (1) internal to the control head.

5. When engaged, tilt the control head until the control head is flat and contacts the gasket.

6. Ensure that the control head fully engages the base plate. Tighten the two set screws until secure contact with the base plate (2) is made, and the control head is held securely in position. Tighten the screws (3) to 1.13 N·m (10.00 lb in).

Drag Setting - Side Mount Control Head

Show/hide table

Illustration 4	g06361480
(1) Remove screw to access drag adjustment

1. Set drag by accessing the drag adjustment screw as shown in Illustration 4.

2. Insert an 1/8 in. hex key wrench into the opening for each lever.

3. Tighten the drag adjustment screws until the desired drag is obtained over the full lever travel.

   Note: 0.45 kg to 0.91 kg (1 to 2 lbs) average drag is normally desirable.

4. Connect, if required, and install the interface harness and secure the strain relieve as necessary.