Overload Warning - Set - If Equipped
Show/hide table
图 1 | g06212547 |
过载警告装置是当动臂油缸管路的泵压力超过设置值时用来警告操作员的系统。 为进行正确调整,应当检查机器上过载警告装置的报警设置。 使用下面的信息输入正确数值,并重设过载警告装置的参数。
注: 发动机转速和 / 或测试期间所用的机器配置可能对测试结果产生影响。 有关此项测试所用的发动机转速,请参阅测试和调整, "发动机性能 - 测试(发动机转速)"。
注: 执行操作检查之前,必须根据卸压阀压力技术规范设定卸压阀压力。 请参阅测试和调整, "技术规范"。
- 选择监视器主菜单中的"设置"。
- 选择"设置"菜单中的"维修"。
- 输入密码 "9992" 并选择 "ENTER(进入)"。
- 从 "Service(维修)"菜单中选择 "Configurations(配置)"。
- 选择"配置"菜单中的"机器附件"。
Show/hide table
图 3 g06212555 - 选择"机器附件"菜单中的"过载压力传感器"。 将"过载压力传感器"设置为"已安装"。
Show/hide table
图 4 g06203538 - 选择"机器附件"菜单中的"过载压力阈值"。 将过载压力阈值设置为
17000 kPa (2465 psi) 。 - 按 "OK(确定)" 将值设置到存储器中。
Show/hide table
图 2 | g06241576 |
Caterpillar Information System:
320 GC, 320 and 323 Excavator Machine Systems Main Hydraulic Pump Air - Purge
320 GC, 320 and 323 Excavator Machine Systems Visual Inspection
320 GC, 320 and 323 Excavator Machine Systems General Testing and Adjusting Information
C175 Tier 4 Final Engines for Off-Highway Trucks Aftercooler - Test
C9.3B Engines for Caterpillar Built Machines Flywheel - Install
Installation of New Cylinder Heads and Camshafts on Certain 3512E Petroleum Tier 4 Final Engines {0703, 1100, 1209, 1210} Installation of New Cylinder Heads and Camshafts on Certain 3512E Petroleum Tier 4 Final Engines {0703, 1100, 1209, 1210}
C12.9 Marine Propulsion Engine Cylinder Liner Projection - Inspect
G3516 Petroleum Engine Hoses and Clamps - Inspect/Replace
Lubrication of the Fuel Injection Pump on Certain C0.5, C0.7, C1.1, C1.5, and C2.2 Engines {1251, 1257, 1265} Lubrication of the Fuel Injection Pump on Certain C0.5, C0.7, C1.1, C1.5, and C2.2 Engines {1251, 1257, 1265}
CX38-P892 Well Servicing Transmission Transmission Hydraulic Control
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Diagnostic Trouble Codes
XQP1100 Generator Set Maintenance Interval Schedule - Prime
320 GC, 320 and 323 Excavator Machine Systems Operational Checks
320 GC, 320 and 323 Excavator Machine Systems Automatic Travel Speed Control - Test
320 GC, 320 and 323 Excavator Machine Systems Machine Drift on a Slope - Check
320 GC, 320 and 323 Excavator Machine Systems Swing Speed and Overswing on Level Ground - Check
320 GC, 320 and 323 Excavator Machine Systems Swing Speed and Swing Drift on a Slope - Check
320 GC, 320 and 323 Excavator Machine Systems Cylinder Drift - Check - Loaded Bucket
320 GC, 320 and 323 Excavator Machine Systems Cylinder Speed - Check
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Event Codes
C175 Tier 4 Final Engines for Off-Highway Trucks Finding the Top Center Position for the No. 1 Piston
Pump Electronic Monitoring System for Well Stimulation Pumps Electrical Power Supply - Test
Pump Electronic Monitoring System for Well Stimulation Pumps Sensor Supply - Test
320 GC, 320 and 323 Excavator Machine Systems Cylinder Drift - Check - Empty Bucket