Machine Drift on a Slope - Check
Show/hide table
"机器在斜坡上的沉降 - 检查" | ||
---|---|---|
沉降 mm (in) | ||
新 | 维修极限 | 来自压力表的 |
0 | 0 |
测量机器在斜坡上的沉降量可以确定是否需要检查行驶制动器。
注: 此项测试所用的机器配置可能会影响该测试结果。 有关此项测试所用的机器配置,请参阅测试和调整, "操作检查"。
注: 执行操作检查之前,必须根据卸压阀压力技术规范设定卸压阀压力。 请参阅测试和调整, "技术规范"。
Show/hide table
说明 | 数量 |
---|---|
秒表 | 1 |
水垢 |
1 |
Show/hide table
图 1 | g06191527 |
- 将机器停放在 12 度斜坡上。 斜坡表面必须坚硬、平滑。
- 如图所示,放置作业机具。 参考图 1。
- 铲斗应空载。
Show/hide table
图 2 g06194735 - 为了指示机器相对于斜坡的位置,在履带和履带支重轮架上均作上标记。 参考图 2。
- 停止发动机。
- 3 分钟后,测量机器在斜坡上的移动量。
Caterpillar Information System:
320 GC, 320 and 323 Excavator Machine Systems Automatic Travel Speed Control - Test
320 GC, 320 and 323 Excavator Machine Systems Operational Checks
320 GC, 320 and 323 Excavator Machine Systems Overload Warning - Set - If Equipped
320 GC, 320 and 323 Excavator Machine Systems Main Hydraulic Pump Air - Purge
320 GC, 320 and 323 Excavator Machine Systems Visual Inspection
320 GC, 320 and 323 Excavator Machine Systems General Testing and Adjusting Information
C175 Tier 4 Final Engines for Off-Highway Trucks Aftercooler - Test
C9.3B Engines for Caterpillar Built Machines Flywheel - Install
Installation of New Cylinder Heads and Camshafts on Certain 3512E Petroleum Tier 4 Final Engines {0703, 1100, 1209, 1210} Installation of New Cylinder Heads and Camshafts on Certain 3512E Petroleum Tier 4 Final Engines {0703, 1100, 1209, 1210}
C12.9 Marine Propulsion Engine Cylinder Liner Projection - Inspect
G3516 Petroleum Engine Hoses and Clamps - Inspect/Replace
Lubrication of the Fuel Injection Pump on Certain C0.5, C0.7, C1.1, C1.5, and C2.2 Engines {1251, 1257, 1265} Lubrication of the Fuel Injection Pump on Certain C0.5, C0.7, C1.1, C1.5, and C2.2 Engines {1251, 1257, 1265}
320 GC, 320 and 323 Excavator Machine Systems Swing Speed and Overswing on Level Ground - Check
320 GC, 320 and 323 Excavator Machine Systems Swing Speed and Swing Drift on a Slope - Check
320 GC, 320 and 323 Excavator Machine Systems Cylinder Drift - Check - Loaded Bucket
320 GC, 320 and 323 Excavator Machine Systems Cylinder Speed - Check
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Event Codes
C175 Tier 4 Final Engines for Off-Highway Trucks Finding the Top Center Position for the No. 1 Piston
Pump Electronic Monitoring System for Well Stimulation Pumps Electrical Power Supply - Test
Pump Electronic Monitoring System for Well Stimulation Pumps Sensor Supply - Test
320 GC, 320 and 323 Excavator Machine Systems Cylinder Drift - Check - Empty Bucket
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting System Schematic
Ring Groove Gauges for 3500 Engines with Square Ring Groove Pistons {0701, 1214, 1215, 1216} Ring Groove Gauges for 3500 Engines with Square Ring Groove Pistons {0701, 1214, 1215, 1216}
CX38-P892 Well Servicing Transmission Transmission Warm-up