Coolant Temperature Is High
Show/hide table
Diagnostic Trouble Codes | |||
Code | Description | Conditions Present | Response |
110-0 | Engine Overheat | Coolant temperature sensor is normal Coolant temperature is greater than or equal to 120° C (248° F) for 5 seconds or more. |
Engine is derated by 25% No EGR operation Intake throttle fully open |
523603-15 | Over Heat Pre-Caution | Coolant temperature sensor is normal Coolant temperature is greater than or equal to 110° C (230° F) |
N/A |
- Low Coolant Level and/or Coolant Leakage
- Coolant Temperature Sensor
- Water Temperature Regulator
- Radiator
- Engine Cooling Fan
- Coolant Pump
- Cylinder Head Gasket
Note: The procedures have been listed in order of probability. Complete the procedures in order.
Show/hide table
Troubleshooting Test Steps | Values | Results |
---|---|---|
1. Check the Engine Coolant Level. A. Inspect the coolant level. |
Engine Coolant Level |
Result: The engine coolant level is OK. Proceed to Test Step 2. Result: The engine coolant level is not OK. Repair : Check the cooling system for leaks. Refer to Troubleshooting, "Coolant Level is Low" for additional information. Repair any leaks immediately. If the problem is not resolved, proceed to Test Step 2. |
2. Check the Cooling System A. Refer to Systems Operation/Testing and Adjusting, "Cooling System - Check (Overheating)" |
Cooling System |
Result: The cooling system is ok.. Proceed to Test Step 3. Result: The cooling system is not ok. Repair : Make the appropriate repairs. If the problem is not resolved, proceed to Test Step 3. |
3. Coolant Temperature Sensor and/or the Circuit A. Check the reading of the coolant temperature on Cat ET. The temperature should rise steadily as the engine is warmed. Ensure that the temperature is reasonable. |
Coolant Temperature Sensor |
Result: The temperature sensor is working properly. Proceed to Test Step 4. Result: The temperature sensor is not working properly. Repair : Troubleshoot the circuit and the coolant temperature sensor. Refer to Troubleshooting, "Sensor Signal (Analog, Passive) - Test". If the problem is not resolved, proceed to Test Step 4. |
4. Water Temperature Regulator A. Pressure-test the cooling system. Refer to Systems Operation/Testing and Adjusting for the correct procedure. B. Check that the seating surfaces the radiator cap are clean and undamaged. C. Check operation of the water temperature regulator. Refer to Systems Operation/Testing and Adjusting, "Water Temperature Regulator - Test" |
Temperature Regulator |
Result:The water temperature regulator is operating properly. Proceed to Test Step 5. Result: The water temperature regulator is not operating properly. Repair : Clean the components and/or replace the components. If the problem is not resolved, proceed to Test Step 5. |
5. Radiator A. Check the radiator fins for dirt, debris, and/or damage. B. Check for collapsed hoses and/or other restrictions. C. Check the radiator for internal blockage. |
Radiator |
Result: The radiator fins are not damaged and the radiator does not have an internal blockage. Proceed to Test Step 6. Result: The radiator fins are damaged. Repair : Remove any dirt and/or debris and straighten any bent fins. Result: The radiator has internal blockage. Repair : Remove the blockage. If the problem is not resolved, proceed to Test Step 6. |
6. Inspection of the Water Pump A. Inspect the impeller of the water pump for damage and/or erosion. B. Make sure that the drive gear is not loose on the drive shaft of the water pump. |
Water Pump |
Result: The water pump is operating correctly. Proceed to Test Step 7. Result: The water pump is not operating correctly. Repair : If necessary, replace the water pump. Refer to Disassembly and Assembly for the correct procedure. If the problem is not resolved, proceed to Test Step 7. |
7. Internal Coolant Leak Refer to Testing and Adjusting, Cooling System - Test. |
Coolant Leak |
Result: There is a coolant leak. Make the necessary repairs and return to service. |
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).
Caterpillar Information System:
C175-16 and C175-20 Locomotive Engines Flywheel Housing - Install
C175-16 and C175-20 Locomotive Engines Engine Oil Pan - Remove
C175-20 Locomotive Engine Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C175-16 Locomotive Engine Emergency Stopping
C175-20 Locomotive Engine Before Starting Engine
C175-20 Locomotive Engine Plate Locations and Film Locations
G3500B Engines Fuel System Operation
323F SA and 323F LN Excavator Diesel Exhaust Fluid Filter - Replace
New Software Is Now Available for Cat® Product Link {7606, 7610, 7620} New Software Is Now Available for Cat® Product Link {7606, 7610, 7620}
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Coolant Level Is Low
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Alternator Problem - Charging Problem and/or Noisy Operation
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Acceleration Is Poor or Throttle Response Is Poor
C175-16 Marine Propulsion Engines Fuel System Verification - Test
C175-16 Locomotive Engine Engine Operation
C175-16 and C175-20 Locomotive Engines Water Pump - Disassemble
New Regulator Service Kits Are Now Available for Certain G3300, G3500, and 3500 Dynamic Gas Blending Engines {1270} New Regulator Service Kits Are Now Available for Certain G3300, G3500, and 3500 Dynamic Gas Blending Engines {1270}
C175-16 and C175-20 Locomotive Engines Water Pump - Assemble
Connecting Rod Bolt Replacement Procedure On Certain C13 Industrial Engines {1218, 1225} Connecting Rod Bolt Replacement Procedure On Certain C13 Industrial Engines {1218, 1225}
C175-16 and C175-20 Locomotive Engines Auxiliary Water Pump - Disassemble
C175-16 and C175-20 Locomotive Engines Engine Oil Pan - Install
C175-16 and C175-20 Locomotive Engines Auxiliary Water Pump - Assemble
TR35 Locomotive Transmission Transmission Oil Pump - Disassemble
TR35 Locomotive Transmission Transmission Oil Pump - Assemble
C175-16 and C175-20 Locomotive Engines Fuel Transfer Pump - Remove