Display Module - Flash Program
Flash the Software onto the Display
The display is shipped blank and will need the software installed. Refer to Special Instruction, REHS7353, "Procedure for Installing Object Detection Software on Monitor Display Group" for software installation instructions.
For most up-to-date software, refer to the most recent Object Detection Service Magazine.
Caterpillar Information System:
Cat® Detect Object Detection System Object Detection Sensor - Adjust
Cat® Detect Object Detection System Diagnostic Code List
Cat® Detect Object Detection System Event Codes
Cat® Detect Object Detection System Operational Problems
C175-16 and C175-20 Locomotive Engines Electronic Control Module (Engine) - Remove and Install
C2.4 Tier 4 Final Engines for Caterpillar Built Machines General Information
G3512 Generator Set Engines Ignition Primary - Test
New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262} New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262}
An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225} An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225}
Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
C7.1 Marine Engine Coolant Level Sensor - Remove and Install
3516E Engines for Caterpillar Built Machines Gear Group (Rear)
DE Series Generator Sets With Cat C3.3 Engine Product Description
C280 Marine Engines SCR Catalyst Temperature Sensor - Test
C175-16 and C175-20 Locomotive Engines Crankshaft - Remove
C175-16 and C175-20 Locomotive Engines Camshaft - Remove
3512E Engines Accumulator (Fuel Injection) - Remove and Install
A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059} A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059}
3512E Engines Fuel Manifold - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Hood - Remove and Install - Left
C175-16 Locomotive Engine Air Inlet Piping - Inspect
Selective Catalytic Reduction Retrofit Aftertreatment Exhaust Temperature Is Low
C11, C13, C15, and C18 Industrial Engines Electrical Power Supply - Test