Event Codes
Show/hide table
Component | Event | Description | Possible Cause |
---|---|---|---|
Battery Supply Voltage | E875 | Voltage Below Normal | System voltage is below normal. There is a possible issue with the charging system. Object detection system and warnings are disabled until the system voltage is above the threshold level. Call your Caterpillar dealer. |
Battery Supply Voltage | E876 | Voltage Above Normal | System voltage is above normal. There is a possible issue with the charging system. The object detection system and warnings are disabled until system voltage is below the threshold level. Call your Caterpillar dealer. |
Front Left Short Range Object Detection Sensor | E1139 | Object Detection Sensor Blockage Detected | The object detection sensor has detected a blockage.
Check for debris in the box that houses the object detection sensor. If debris is present, remove the debris. Clean the plastic cover that is on the object detection sensor housing in order to remove mud or debris. An object that is too close to the object detection sensor can also cause this event. |
Front Right Short Range Object Detection Sensor | E1140 | Object Detection Sensor Blockage Detected | |
Rear Left Short Range Object Detection Sensor | E1141 | Object Detection Sensor Blockage Detected | |
Rear Right Short Range Object Detection Sensor | E1142 | Object Detection Sensor Blockage Detected | |
Front Left Medium Range Object Detection Sensor | E1143 | Object Detection Sensor Blockage Detected | |
Front Right Medium Range Object Detection Sensor | E1144 | Object Detection Sensor Blockage Detected | |
Left Top Medium Range Object Detection Sensor | E1145 | Object Detection Sensor Blockage Detected | |
Left Bottom Medium Range Object Detection Sensor | E1146 | Object Detection Sensor Blockage Detected | |
Rear Left Medium Range Object Detection Sensor | E1147 | Object Detection Sensor Blockage Detected | |
Rear Right Medium Range Object Detection Sensor | E1148 | Object Detection Sensor Blockage Detected | |
Right Top Medium Range Object Detection Sensor | E1149 | Object Detection Sensor Blockage Detected | |
Right Bottom Medium Range Object Detection Sensor | E1150 | Object Detection Sensor Blockage Detected |
Caterpillar Information System:
Cat® Detect Object Detection System Operational Problems
C175-16 and C175-20 Locomotive Engines Electronic Control Module (Engine) - Remove and Install
C2.4 Tier 4 Final Engines for Caterpillar Built Machines General Information
G3512 Generator Set Engines Ignition Primary - Test
New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262} New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262}
An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225} An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225}
Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
C7.1 Marine Engine Coolant Level Sensor - Remove and Install
C7.1 Marine Engine Engine Oil Pan - Remove and Install
3500B Locomotive Engines Overhaul (Top End)
C7.1 Marine Engine Crankcase Breather - Remove
Cat® Detect Object Detection System Diagnostic Code List
Cat® Detect Object Detection System Object Detection Sensor - Adjust
Cat® Detect Object Detection System Display Module - Flash Program
3516E Engines for Caterpillar Built Machines Gear Group (Rear)
DE Series Generator Sets With Cat C3.3 Engine Product Description
C280 Marine Engines SCR Catalyst Temperature Sensor - Test
C175-16 and C175-20 Locomotive Engines Crankshaft - Remove
C175-16 and C175-20 Locomotive Engines Camshaft - Remove
3512E Engines Accumulator (Fuel Injection) - Remove and Install
A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059} A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059}
3512E Engines Fuel Manifold - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Hood - Remove and Install - Left