Hood - Remove and Install - Left
Start By:
- Remove Right-Hand Hood
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 422-5472 | Lifting Eye Assembly | 3 |
- Use two of Tooling (A) and a suitable lifting device to support left-hand hood (1) in the open position. The weight of left-hand hood (1) is approximately
95 kg (210 lb) Show/hide tableIllustration 2 g06093674 - Remove retaining clip (2). Disconnect gas spring assembly (3). Repeat process for gas spring assembly (4).
- Return the left-hand hood to the closed position.
Show/hide table
Illustration 3 g06093863 - Install remaining Tooling (A) into bolt hole (6). Use suitable lifting device to support hood (1). The weight of left-hand hood (1) is approximately
95 kg (210 lb) . - Remove four bolts (5). Remove left-hand hood (1).
Show/hide table
Illustration 1 | g06093667 |
- Install left-hand hood (1) in the reverse order of removal.
Caterpillar Information System:
3512E Engines Fuel Manifold - Remove and Install
A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059} A New Wastegate Bellows Assembly Is Used for Certain 3512C Heavy-Duty Locomotive Engines {1059}
3512E Engines Accumulator (Fuel Injection) - Remove and Install
C175-16 and C175-20 Locomotive Engines Camshaft - Remove
C175-16 and C175-20 Locomotive Engines Crankshaft - Remove
C280 Marine Engines SCR Catalyst Temperature Sensor - Test
DE Series Generator Sets With Cat C3.3 Engine Product Description
3516E Engines for Caterpillar Built Machines Gear Group (Rear)
Cat® Detect Object Detection System Display Module - Flash Program
Cat® Detect Object Detection System Object Detection Sensor - Adjust
Cat® Detect Object Detection System Diagnostic Code List
Cat® Detect Object Detection System Event Codes
C175-16 Locomotive Engine Air Inlet Piping - Inspect
Selective Catalytic Reduction Retrofit Aftertreatment Exhaust Temperature Is Low
C11, C13, C15, and C18 Industrial Engines Electrical Power Supply - Test
C175-16 and C175-20 Locomotive Engines Aftercooler - Remove and Install
C13 Engines for Caterpillar Built Machines Speed/Timing - Test
C175-16 Locomotive Engines Fuel Injector - Replace
C13 Engines for Caterpillar Built Machines Timing - Calibrate
C175-16 and C175-20 Locomotive Engines Camshaft - Install
Setup for Certain G3306TA Air/Fuel Ratio Control Engines with a Wide Band O2 Sensor {108H, 1408, 1920} Setup for Certain G3306TA Air/Fuel Ratio Control Engines with a Wide Band O2 Sensor {108H, 1408, 1920}
C13 Engines for Caterpillar Built Machines Configuration Parameters
C11, C13, C15, and C18 Industrial Engines Data Link - Test
C13 Engines for Caterpillar Built Machines Retarder - Test