Cylinder Liner - Remove and Install
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 487-3138 | Puller | 1 |
| B | 487-3139 | Plate | 1 |
| C | 2P-8260 | Cylinder Liner Installer | 1 |
| D | 5P-3975 | Rubber Lubricant | 1 |
Start By:
- Remove the pistons and connecting rods
- Use Tooling (A) and Tooling (B) to remove cylinder liner (1).
Show/hide table
Illustration 3 g06087611 - Remove O-ring seals (2) from cylinder liner (1).
Show/hide table
| |
| Illustration 1 | g06087586 |
|
Top view. | |
Show/hide table
| |
| Illustration 2 | g06087560 |
|
Bottom view. | |
- Install O-ring seals (2) onto cylinder liner (1).
- Apply Tooling (D) to the O-ring seals.
Note: Refer to Testing and Adjusting, "Cylinder Liner Projection" for more information.
- Use Tooling (C) to install cylinder liner (1).
Show/hide table
| |
| Illustration 4 | g01133518 |
Caterpillar Information System:
C1.7 and C2.2 Industrial Engines Crankshaft
A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201} A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201}
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Control Panel - Cat Marine Power Display (MPD) Control Panel (If Equipped)
C12.9 Marine Engines Pistons and Connecting Rods - Assemble
3516E Engines for Caterpillar Built Machines Crankshaft
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Lifting
C1.7 and C2.2 Industrial Engines Cylinder Head
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Plate Locations and Film Locations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Description
PG145 Transmission Oil Filter (Transmission)
PG145 Transmission Gear Pump (Transmission)
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Model View Illustrations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Monitoring System - Diagnostic Trouble Codes and Event Codes
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Configuration Parameters
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Before Starting Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting the Engine
Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067} Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067}
3516E Engines for Caterpillar Built Machines Gear Group (Front)
3516E Engines Engine Speed/Timing Sensor - Remove and Install
3516E Engines Atmospheric Pressure Sensor - Remove and Install
3516E Engines Engine Speed Sensor - Remove and Install
3516E Engines Crankshaft - Remove
3516E Engines Crankshaft - Install
3512E Tier 4 Final Engines for Land Electric Drilling Water Pump