Oil Filter (Transmission)
Show/hide table
| |
| Illustration 1 | g06088073 |
|
Left side view of the transmission (1) Oil filter (transmission) | |
The oil filter (transmission) (1) is on the left side of the transmission.
The oil filter is a full flow design. To ensure that all contaminants are removed from the transmission oil, the filter base is not equipped with a bypass valve. Oil from the charge pump flows immediately to the oil filter. After the filter, oil then flows to the clutch circuit and to the torque converter inlet.
Caterpillar Information System:
PG145 Transmission Gear Pump (Transmission)
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Model View Illustrations
PG145 Transmission Torque Converter
PG145 Transmission Transmission Power Flow
PG145 Transmission Hydraulic System Schematic
PG145 Transmission Location of Hydraulic Components for Transmission System
PG145 Transmission Location of Electronic Components for Transmission System
PG145 Transmission General Information
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Does Not Crank
G3512 Generator Set Engines Generator Output Power - Test
3516E Engines Coolant Temperature Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Cranks but Does Not Start
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Description
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Plate Locations and Film Locations
C1.7 and C2.2 Industrial Engines Cylinder Head
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Lifting
3516E Engines for Caterpillar Built Machines Crankshaft
C12.9 Marine Engines Pistons and Connecting Rods - Assemble
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Control Panel - Cat Marine Power Display (MPD) Control Panel (If Equipped)
A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201} A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201}
C1.7 and C2.2 Industrial Engines Crankshaft
C12.9 Marine Engines Cylinder Liner - Remove and Install
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Monitoring System - Diagnostic Trouble Codes and Event Codes
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Configuration Parameters