Crankshaft
Show/hide table
| |
| Illustration 1 | g06087433 |
Show/hide table
| Specification for 418-2346 Crankshaft Gp | |||
|---|---|---|---|
| Item | Qty | Part | Specification Description |
| 1 | 2 | 7C-6209 Thrust Plate | Thrust plates should be used only on center main bearing. |
| 2 | 8 | 2W-2288 Plug | Torque to |
| 3 | 32 | 7N-2003 Dowel | Protrusion (B) of the dowel is |
| 4 | 48 | 128-4845 Bolt As | Use the following procedure in order to tighten the bolts:
1. Before assembly, lubricate the bolt threads, the bolt shank, the washer, and the underside of the bolt head with molylube. NOTE: Torque outer bolts first, then torque inner bolt. 2. Tighten the bolts evenly to 3. Again, tighten each bolt for an additional angle of 120 ± 5 degrees. |
| - | - | - | After assembly into cylinder block, end play of the new crankshaft is |
Caterpillar Information System:
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Lifting
C1.7 and C2.2 Industrial Engines Cylinder Head
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Plate Locations and Film Locations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Product Description
PG145 Transmission Oil Filter (Transmission)
PG145 Transmission Gear Pump (Transmission)
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Model View Illustrations
PG145 Transmission Torque Converter
PG145 Transmission Transmission Power Flow
PG145 Transmission Hydraulic System Schematic
PG145 Transmission Location of Hydraulic Components for Transmission System
PG145 Transmission Location of Electronic Components for Transmission System
C12.9 Marine Engines Pistons and Connecting Rods - Assemble
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Control Panel - Cat Marine Power Display (MPD) Control Panel (If Equipped)
A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201} A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201}
C1.7 and C2.2 Industrial Engines Crankshaft
C12.9 Marine Engines Cylinder Liner - Remove and Install
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Monitoring System - Diagnostic Trouble Codes and Event Codes
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Configuration Parameters
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Before Starting Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting the Engine
Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067} Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067}
3516E Engines for Caterpillar Built Machines Gear Group (Front)
3516E Engines Engine Speed/Timing Sensor - Remove and Install