Engine Speed Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the harness assembly .
- Remove engine speed sensor (1) from the flywheel housing.
Show/hide table
| |
| Illustration 1 | g06087706 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine speed sensor (1) in the flywheel housing. Tighten the engine speed sensor to a torque of
40 ± 5 N·m (30 ± 3.5 lb ft) . - Connect harness assembly (1).
Show/hide table
|
| |
| Illustration 2 | g06087706 |
Caterpillar Information System:
3516E Engines Atmospheric Pressure Sensor - Remove and Install
3516E Engines Engine Speed/Timing Sensor - Remove and Install
3516E Engines for Caterpillar Built Machines Gear Group (Front)
Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067} Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067}
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting the Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Before Starting Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Configuration Parameters
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Monitoring System - Diagnostic Trouble Codes and Event Codes
C12.9 Marine Engines Cylinder Liner - Remove and Install
C1.7 and C2.2 Industrial Engines Crankshaft
A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201} A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201}
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Control Panel - Cat Marine Power Display (MPD) Control Panel (If Equipped)
3516E Engines Crankshaft - Remove
3516E Engines Crankshaft - Install
3512E Tier 4 Final Engines for Land Electric Drilling Water Pump
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Cold Weather Starting
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Refill Capacities
TR35 Railway Transmission Lubricant Viscosities - Fluids Recommendations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Engine Oil Level - Check
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Maintenance Recommendations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting Motor - Inspect
3516E Engines Exhaust Elbow - Remove and Install
3516E Engines Exhaust Manifold - Remove and Install
C175–16 Locomotive Engine Turbocharger