Atmospheric Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the harness assembly and remove atmospheric pressure sensor (1).
- Remove the O-ring seal from the atmospheric pressure sensor.
Show/hide table
Illustration 1 | g06087705 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on atmospheric pressure sensor (1).
- Install atmospheric pressure sensor (1) and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect the harness assembly.
Show/hide table
Illustration 2 | g06087705 |
Caterpillar Information System:
3516E Engines Engine Speed/Timing Sensor - Remove and Install
3516E Engines for Caterpillar Built Machines Gear Group (Front)
Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067} Remote Oil Filter Installation Is Now Available for Certain CX31 Transmissions {3067}
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting the Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Before Starting Engine
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Configuration Parameters
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Monitoring System - Diagnostic Trouble Codes and Event Codes
C12.9 Marine Engines Cylinder Liner - Remove and Install
C1.7 and C2.2 Industrial Engines Crankshaft
A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201} A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on C15 And C18 Engines {1100, 1124, 1201}
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Control Panel - Cat Marine Power Display (MPD) Control Panel (If Equipped)
C12.9 Marine Engines Pistons and Connecting Rods - Assemble
3516E Engines Engine Speed Sensor - Remove and Install
3516E Engines Crankshaft - Remove
3516E Engines Crankshaft - Install
3512E Tier 4 Final Engines for Land Electric Drilling Water Pump
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Cold Weather Starting
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Refill Capacities
TR35 Railway Transmission Lubricant Viscosities - Fluids Recommendations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Engine Oil Level - Check
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Maintenance Recommendations
3512C HD and 3516C HD Class I Division 2 Hazardous Location Generator Sets Starting Motor - Inspect
3516E Engines Exhaust Elbow - Remove and Install
3516E Engines Exhaust Manifold - Remove and Install