Engine Oil Filter Base - Remove and Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 185-3630 | Strap Wrench | 1 |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect hose assemblies (2).
- Use Tooling (A) to remove engine oil filter (4) from engine oil filter base (1).
- Remove bolts (3). Remove engine oil filter (4).
Show/hide table
Illustration 1 | g03557137 |
- Install engine oil filter base (1) in the reverse order of removal.
Caterpillar Information System:
2013/12/23 A New Oil Pump and Tube Assemblies Are Now Used for Certain C9 Engines {1304, 1315}
2013/12/18 New Insulation Design Is Used On SCR Retrofit Aftertreatment Systems {1067}
303.5E2 CR, 304E2 CR, 304.5E2 XTC, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Hydraulic System Relief Valve (Line)
C4.4 Marine Generator Set Safety Messages
G3500H 60Hz Generator Sets Rotating Rectifier - Check
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Generator Winding Insulation - Test
G3500H 60Hz Generator Sets Generator Set Alignment - Check - Generator Sets
G3512 Generator Set Generator Bearing - Lubricate
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Generator Bearing - Inspect
G3500H 60Hz Generator Sets Generator - Dry
797F and 797F XQ Off-Highway Truck/Tractor Braking System Valve (Unloader)
G3500H 60Hz Generator Sets Coolant (NGEC) - Change
330F MHPU Mobile Hydraulic Power Unit Machine System Cab Lighting
G3600 A4 Engines Engine Cranks but Does Not Start
C4.4 Marine Generator Set Mounting and Dismounting
G3600 A4 Engines Engine Stalls Immediately After Starting
G3600 A4 Engines Exhaust Emission and Fuel Consumption Are High
Three60 Precision Control System Event Codes
C280-08 Tier 4 Engine Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
C280-08 Tier 4 Engine Temperature Sensor (Exhaust Outlet) - Remove and Install
Crimping Permanent Couplings Using the 136-3642 Crimp Tool Group in Combination and XT Hose Machines{0374, 0599, 0684, 5057} Crimping Permanent Couplings Using the 136-3642 Crimp Tool Group in Combination and XT Hose Machines{0374, 0599, 0684, 5057}
Inspecting the Grease Chute On Certain 3000 Frame Generator Sets{4459, 5258} Inspecting the Grease Chute On Certain 3000 Frame Generator Sets{4459, 5258}
CG137-12 Petroleum Generator Set Engine Housing (Front)
CG137-12 Petroleum Generator Set Engine Exhaust Manifold - Water Cooled