Engine Speed/Timing Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness (2) and remove engine speed/timing sensor.
- Remove O-ring seal.
Show/hide table
Illustration 1 | g03413357 |
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 5P-3931 | Anti-Seize Compound | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine speed/timing sensor (2) in the reverse order of removal.
- Apply Tooling (A) to the threads of engine speed/timing sensor (2) and tighten to a torque of
25 ± 5 N·m (18 ± 4 lb ft) .
- Apply Tooling (A) to the threads of engine speed/timing sensor (2) and tighten to a torque of
Caterpillar Information System:
C13, C15, and C18 Generator Set Engines Piston and Rings
2013/08/06 Improved Clamps are Now Used for the Cooling Lines Group on Certain Excavators {1351}
3512C Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
2013/08/09 New Software Is Used on Certain 3500 Petroleum Engines {1901, 1920}
3512E Engines for Well Stimulation Pumps Auxiliary Drive Shaft
C175-20 Locomotive Engine Fuel System Operation
3516C Petroleum Engines Flywheel Housing
2013/11/25 New Breather Assemblies Are Now Used on Certain C175 Engines {1317}
2013/08/30 New Software and Low Pressure Fuel System Are Used in Certain C175 Engines {1250, 1901, 1902}
UPS 750 Uninterruptible Power Supply DC Bus Capacitor - Replace
3516C Marine Engines Engine Oil Lines
C13 Generator Set Engine Fan - Remove and Install
2013/08/06 A New Upgraded Starter Is Used for Certain 3512, 3512B, 3512B HD, and 3512CEngines {1453}
2015/05/29 Improved Camshafts Are Now Used on Certain C15 and C18 Machine Engines {1210}
2013/08/15 Improved Camshafts Are Now Used on Certain C15 and C18 Engines {1210}
C7.1 Engines Diesel Particulate Filter Temperature Is Low
C13 Generator Set Engine Alternator - Remove and Install
3516C Locomotive Engines Selective Catalytic Reduction Relay - Test
330F MHPU Mobile Hydraulic Power Unit Machine System Solenoid Valve (Proportional Reducing) - Calibrate - Boom Down Regeneration
2013/09/09 A New Elbow Is Used on Certain 3500 Engines {1371}
C13 Generator Set Engine Electronic Control Module - Remove and Install
C13 Generator Set Engine Electric Starting Motor - Remove and Install
349F and 352F Excavator Machine System Connector Locations
3512E Petroleum Engines Fuel Priming Pump - Remove and Install