Fan - Remove and Install
Start By:
- Remove the fan guard.
- Disconnect the negative battery terminal. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Show/hide table
Illustration 1 g03412470 - Remove bolts (2). Remove fan (2) and plate clamp (3).
- Install fan (1) in the reverse order of removal.
- Dimension (X) is the clearance between the fan blade and the fan shroud assembly. Dimension (X) is
14 mm (0.55118 inch) or greater. Check the clearance at each fan blade.Show/hide tableIllustration 3 g03423580 - To adjust the clearance between the fan blade and the fan shroud assembly. Loosen bolts (5) and move radiator and aftercooler assembly (4) until clearance is obtained.
Show/hide tableIllustration 2 g03423579 - Dimension (X) is the clearance between the fan blade and the fan shroud assembly. Dimension (X) is
Caterpillar Information System:
C3.4B Industrial Engine Fuel Related Components in Cold Weather
3516C Marine Engines Water Lines
2013/07/30 New Service Replacement Stator Part Numbers for Certain XQ60, XQ100, and XQ175 Generator Sets are Now Available {4453}
2015/08/19 An Improved Seat Belt Group is Now Available for 311 through 390 Excavators {7327}
C27 and C32 Generator Sets Product Description
371-0351 Hydraulic Valve Seat Puller Group {0374, 0599, 0700, 0703} 371-0351 Hydraulic Valve Seat Puller Group {0374, 0599, 0700, 0703}
C7.1 Engines Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Fan Drive - Assemble
C13 Generator Set Engine Fan Drive - Disassemble
C9.3 Industrial Engine Product Lifting
EMCPll+ Software Not Compatible With Certain G3400 Engines{4490} EMCPll+ Software Not Compatible With Certain G3400 Engines{4490}
C9.3 Industrial Engine Plate Locations and Film Locations
3516C Marine Engines Engine Oil Lines
UPS 750 Uninterruptible Power Supply DC Bus Capacitor - Replace
2013/08/30 New Software and Low Pressure Fuel System Are Used in Certain C175 Engines {1250, 1901, 1902}
2013/11/25 New Breather Assemblies Are Now Used on Certain C175 Engines {1317}
3516C Petroleum Engines Flywheel Housing
C175-20 Locomotive Engine Fuel System Operation
3512E Engines for Well Stimulation Pumps Auxiliary Drive Shaft
2013/08/09 New Software Is Used on Certain 3500 Petroleum Engines {1901, 1920}
3512C Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
2013/08/06 Improved Clamps are Now Used for the Cooling Lines Group on Certain Excavators {1351}
C13, C15, and C18 Generator Set Engines Piston and Rings
3512C Petroleum Engines Engine Speed/Timing Sensor - Remove and Install