Engine Oil Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness (2) and remove engine oil pressure sensor (1).
- Remove the O-ring seal from engine oil pressure sensor (1).
Show/hide table
Illustration 1 | g03413202 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil pressure sensor (1) in the reverse order of removal.
- Tighten engine oil pressure sensor (1) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten engine oil pressure sensor (1) to a torque of
Caterpillar Information System:
2013/08/09 New Software Is Used on Certain 3500 Petroleum Engines {1901, 1920}
3512E Engines for Well Stimulation Pumps Auxiliary Drive Shaft
C175-20 Locomotive Engine Fuel System Operation
3516C Petroleum Engines Flywheel Housing
2013/11/25 New Breather Assemblies Are Now Used on Certain C175 Engines {1317}
2013/08/30 New Software and Low Pressure Fuel System Are Used in Certain C175 Engines {1250, 1901, 1902}
UPS 750 Uninterruptible Power Supply DC Bus Capacitor - Replace
3516C Marine Engines Engine Oil Lines
C13 Generator Set Engine Fan - Remove and Install
C3.4B Industrial Engine Fuel Related Components in Cold Weather
3516C Marine Engines Water Lines
2013/07/30 New Service Replacement Stator Part Numbers for Certain XQ60, XQ100, and XQ175 Generator Sets are Now Available {4453}
2013/08/06 Improved Clamps are Now Used for the Cooling Lines Group on Certain Excavators {1351}
C13, C15, and C18 Generator Set Engines Piston and Rings
3512C Petroleum Engines Engine Speed/Timing Sensor - Remove and Install
2013/08/06 A New Upgraded Starter Is Used for Certain 3512, 3512B, 3512B HD, and 3512CEngines {1453}
2015/05/29 Improved Camshafts Are Now Used on Certain C15 and C18 Machine Engines {1210}
2013/08/15 Improved Camshafts Are Now Used on Certain C15 and C18 Engines {1210}
C7.1 Engines Diesel Particulate Filter Temperature Is Low
C13 Generator Set Engine Alternator - Remove and Install
3516C Locomotive Engines Selective Catalytic Reduction Relay - Test
330F MHPU Mobile Hydraulic Power Unit Machine System Solenoid Valve (Proportional Reducing) - Calibrate - Boom Down Regeneration
2013/09/09 A New Elbow Is Used on Certain 3500 Engines {1371}
C13 Generator Set Engine Electronic Control Module - Remove and Install