Belt Tension Chart
Show/hide table
Belt Tension Chart for Alternator and Fan Belts | ||||||
---|---|---|---|---|---|---|
Gauge Reading | ||||||
Initial Belt Tension(1) | Used Belt Tension(2) | |||||
|
|
Show/hide table
(1) | Initial Belt Tension refers to a new belt. |
(2) | Used Belt Tension refers to a belt that has been in operation for 30 minutes or more at the rated speed. |
Show/hide table
Belt Tension Chart for Air Pump Belts | |
---|---|
Gauge Reading | |
Initial Belt Tension(1) | Used Belt Tension(2) |
|
|
Show/hide table
(1) | Initial Belt Tension refers to a new belt. |
(2) | Used Belt Tension refers to a belt that has been in operation for 30 minutes or more at the rated speed. |
Note: Use a 144-0235 Belt Tension Gauge to measure the tension of the belts.
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Machines Piston and Rings
C13, C15, and C18 Tier 4 Final Engines Exhaust Cooler (NRS)
C9.3 Tier 4 Final Engines Inlet Manifold Air Pressure Sensor
C6.6 Generator Sets Refill Capacities
CX31 On-Highway Transmission Torque Converter Housing
C3.4B Industrial Engine Plate Locations and Film Locations - Aftertreatment
C32 Generator Set Overhaul Considerations
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Design
C280-16 Engine Fuel Filter Housings - Remove
374F Excavator Hydraulic System General Information (Swing System)
G3500H Generator Set Engine Sensor Supply - Test
C13 Tier 4 Final Engines Engine Design
C3.3B Engines for Caterpillar Built Machines Camshaft Position Sensor Bushing - Remove and Install
C280-16 Engine Fuel Filter Housings - Disassemble
C280-16 Engine Fuel Filter Housings - Assemble
C280-16 Engine Fuel Filter Housings - Install
C13, C15, and C18 Tier 4 Final Engines Nitrogen Oxide Sensor - Engine Exhaust Out
C13, C15, and C18 Tier 4 Final Engines Nitrogen Oxide Sensor - Exhaust Pipe Out
3512E Land Electric Drive Coolant (ELC) - Change
3512E Land Electric Drive Coolant (DEAC) - Change
C7.1 Marine Generator Set Control Panel - EMCP 4.2 (If Equipped)
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Electronic Service Tool Does Not Communicate
3516C HD Petroleum Well Service Engines Electronic Control Module (ECM)
C13, C15, and C18 Tier 4 Final Engines Relay (ARD Nozzle Heater)