Fuel Filter Housings - Remove
Start By:
- Remove the fuel filter elements. Refer to Disassembly and Assembly, "Fuel Filters - Remove and Install".
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 g03375073 - Disconnect tube assembly (1) and tube assembly (2).
Show/hide table
Illustration 2 g03375128 - Attach a suitable lifting device to fuel filter housing (4). Fuel filter housing (4) weighs approximately
75 kg (165 lb) . - Remove bolts (3) and fuel filter housing (4).
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Caterpillar Information System:
374F Excavator Hydraulic System General Information (Swing System)
G3500H Generator Set Engine Sensor Supply - Test
C13 Tier 4 Final Engines Engine Design
3512C Petroleum Engines Coolant Diverter - Test
C4.4 and C7.1 Engines Sensor Signal (Analog, Passive) - Test
320E and 323E Excavators Machine System Specifications Control Valve (Stick Lowering)
3500B Industrial Engines Maintenance Interval Schedule
3516B and 3516C Engines For MT4400D AC Off-Highway Trucks Power Is Intermittently Low or Power Cutout Is Intermittent
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Door Latch
C280-16 Engine Alarms and Shutoffs
374F Excavator Hydraulic System General Information (Bucket System)
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Pump - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Design
C32 Generator Set Overhaul Considerations
C3.4B Industrial Engine Plate Locations and Film Locations - Aftertreatment
CX31 On-Highway Transmission Torque Converter Housing
C6.6 Generator Sets Refill Capacities
C9.3 Tier 4 Final Engines Inlet Manifold Air Pressure Sensor
C13, C15, and C18 Tier 4 Final Engines Exhaust Cooler (NRS)
C1.5 and C2.2 Engines for Caterpillar Built Machines Piston and Rings
C1.5 and C2.2 Engines for Caterpillar Built Machines Belt Tension Chart
C3.3B Engines for Caterpillar Built Machines Camshaft Position Sensor Bushing - Remove and Install
C280-16 Engine Fuel Filter Housings - Disassemble
C280-16 Engine Fuel Filter Housings - Assemble