Engine Design
C13
Show/hide table
图 1 | g01193927 |
(A) 排气门 (B) 进气门 |
缸径 ... 130 mm
(5.12 in)
冲程 ... 157 mm
(6.18 in)
排量 ... 12.5 L
(760 cu in)
气缸布置 ... 直列式
每气缸气门数 ... 4
为检查发动机气门间隙的设定值,发动机必须是冷机且发动机必须停止。
发动机气门间隙
- 进气 ... 0.38 ± 0.08 mm
(0.015 ± 0.003 in)- 排气 ... 0.76 ± 0.08 mm
(0.030 ± 0.003 in) - 排气 ... 0.76 ± 0.08 mm
燃烧类型 ... 直喷式
点火顺序 ... 1-5-3-6-2-4
曲轴旋转方向是通过从发动机飞轮端观察来确定的。 曲轴旋向 ... 逆时针
注: 发动机的前端是指与发动机飞轮端相对的一端。 发动机左右侧是通过从发动机飞轮端观察来确定的。 1 号气缸是前气缸。
Caterpillar Information System:
3512C Petroleum Engines Coolant Diverter - Test
C4.4 and C7.1 Engines Sensor Signal (Analog, Passive) - Test
320E and 323E Excavators Machine System Specifications Control Valve (Stick Lowering)
3500B Industrial Engines Maintenance Interval Schedule
3516B and 3516C Engines For MT4400D AC Off-Highway Trucks Power Is Intermittently Low or Power Cutout Is Intermittent
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Door Latch
C280-16 Engine Alarms and Shutoffs
374F Excavator Hydraulic System General Information (Bucket System)
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Pump - Remove and Install
2013/07/24 Improved Ignition Harness for G3500 Engines {1408}
374F Excavator Hydraulic System General Information (Stick System)
UPS 750 Uninterruptible Power Supply Remote Status Panel
G3500H Generator Set Engine Sensor Supply - Test
374F Excavator Hydraulic System General Information (Swing System)
C280-16 Engine Fuel Filter Housings - Remove
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Design
C32 Generator Set Overhaul Considerations
C3.4B Industrial Engine Plate Locations and Film Locations - Aftertreatment
CX31 On-Highway Transmission Torque Converter Housing
C6.6 Generator Sets Refill Capacities
C9.3 Tier 4 Final Engines Inlet Manifold Air Pressure Sensor
C13, C15, and C18 Tier 4 Final Engines Exhaust Cooler (NRS)
C1.5 and C2.2 Engines for Caterpillar Built Machines Piston and Rings
C1.5 and C2.2 Engines for Caterpillar Built Machines Belt Tension Chart