NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Do not open the high pressure fuel system without allowing the fuel system to purge. After the engine has shut down, allow the fuel system to purge for ten minutes. This operating fuel system contains high pressure. Exposure to high pressure fuel can result in personal injury. |
- Use a mirror to remove bolts (2). Remove fuel control valve (1).
Show/hide table
Illustration 2 g01347728 - Check O-ring seals (3), (4), and (5) on fuel control valve (1).
Illustration 1 | g01347715 |
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 5N-5561 | Silicone Lubricant | 1 |
- Lubricate O-ring seals (3), (4), and (5) with Tooling (A).
Show/hide table
Illustration 4 g01347715 Show/hide tableIllustration 5 g01347742 - Position fuel control valve (1). Install bolts (2). Tighten bolts (2) in the sequence that is shown in Illustration 5. Tighten bolts (2) to a torque of
6 N·m (53 lb in) . Tighten bolts (2) in the sequence that is shown in Illustration 5. Tighten bolts (2) to a torque of12 N·m (106 lb in) .
Illustration 3 | g01347728 |