Fuel Priming Pump - Remove and Install
- Turn the fuel supply to the OFF position.
Show/hide table
Illustration 1 g01216054 - Disconnect hose assemblies (1) and (3). Disconnect harness assembly (4). Remove bolts (2). Remove fuel priming pump (5).
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel priming pump (5). Install bolts (2). Connect harness assembly (4). Connect hose assemblies (1) and (3).
- Turn the fuel supply to the ON position.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| |
| Illustration 2 | g01216054 |
Caterpillar Information System:
2012/11/12 A New Seat Kit is Now Available for Certain Excavators and Mobile Hydraulic Power Units {7312}
C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Has Excessive Black Smoke
C175-16 Generator Set Engine Fuel Filter Housing - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Vibration Is Excessive
C175-16 Generator Set Engine Electronic Control Module (Engine) - Remove and Install
C1.5 and C2.2 Industrial Engines Engine Top Speed Is Not Obtained
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Stalls at Low RPM
Alternator - Bosch K1/N1 Insulated Screw - Check
C1.5 and C2.2 Industrial Engines Engine Speed Does Not Change
Alternator - Bosch K1/N1 Residual Magnetism - Restore
G3520E Generator Set Engines Engine Oil Filter
G3516C and G3516E Gas Engines Cylinder Head Valves
C32 Marine Engines Unit Injector - Install
C175-16 Generator Set Engine Fuel Transfer Pump - Remove and Install
C32 Marine Engines Unit Injector - Remove
C1.5 and C2.2 Industrial Engines Exhaust Has Excessive White Smoke
C32 Marine Engines Camshaft Bearings - Remove
C175-16 Generator Set Engine High Pressure Fuel Rails - Remove and Install
C32 Marine Engines Camshaft Bearings - Install
C175-16 PETROLEUM ENGINES Flow Limiter - Remove and Install
C175-16 Generator Set Engine Fuel Control Valve - Remove and Install - Primary
2012/10/24 A New Water Temperature Regulator Is Available for Certain Commercial Engines {1355}
C175-16 Generator Set Engine Fuel Pump (High Pressure) - Remove and Install
C32 Marine Engines Cylinder Liner - Remove