Fuel Transfer Pump - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 339-9353 | High Press. Cap Kit | 1 |
265-2256 | Wipers | 1 |
- Turn the fuel supply to the OFF position.
Show/hide table
Illustration 1 g03194459 - Disconnect hose assemblies (1) and tube assembly (2).
Show/hide table
Illustration 2 g03200059 - Remove bolts (4) and remove fuel transfer pump (3).
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Use Tooling (A) to cap tube assemblies, fittings, ports, and openings on the fuel system in order to prevent contamination.
- Install fuel transfer pump (3) in the reverse order of removal.
Caterpillar Information System:
C32 Marine Engines Unit Injector - Install
C175-16 Generator Set Engine Fuel Priming Pump - Remove and Install
2012/11/12 A New Seat Kit is Now Available for Certain Excavators and Mobile Hydraulic Power Units {7312}
C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Has Excessive Black Smoke
C175-16 Generator Set Engine Fuel Filter Housing - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Vibration Is Excessive
C175-16 Generator Set Engine Electronic Control Module (Engine) - Remove and Install
C1.5 and C2.2 Industrial Engines Engine Top Speed Is Not Obtained
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Stalls at Low RPM
Alternator - Bosch K1/N1 Insulated Screw - Check
C1.5 and C2.2 Industrial Engines Engine Speed Does Not Change
Alternator - Bosch K1/N1 Residual Magnetism - Restore
C32 Marine Engines Unit Injector - Remove
C1.5 and C2.2 Industrial Engines Exhaust Has Excessive White Smoke
C32 Marine Engines Camshaft Bearings - Remove
C175-16 Generator Set Engine High Pressure Fuel Rails - Remove and Install
C32 Marine Engines Camshaft Bearings - Install
C175-16 PETROLEUM ENGINES Flow Limiter - Remove and Install
C175-16 Generator Set Engine Fuel Control Valve - Remove and Install - Primary
2012/10/24 A New Water Temperature Regulator Is Available for Certain Commercial Engines {1355}
C175-16 Generator Set Engine Fuel Pump (High Pressure) - Remove and Install
C32 Marine Engines Cylinder Liner - Remove
2012/10/08 Check Valves Are Now Used in the Fuel System of Certain Electric Power Generation and Industrial Engines {1250, 1261, 5067}
C32 Marine Engines Cylinder Liner - Install